Optical protection switching using 2 by 2 switching functions
作者： Hiroki Ikeda , Shigeki Kitajima , Shoichi Hanatani
DOI:
关键词: Electric power transmission 、 Connection (vector bundle) 、 Engineering 、 Optical fiber transmission 、 Fault (power engineering) 、 Electronic engineering 、 Reliability (computer networking) 、 Signal
摘要: A network is protected against interruption of service while one or more faulty switches optical fiber transmission lines are repaired replaced, by an interconnecting configuration small N×N input/output switches, where N 2 greater than 2. The configured among protection and working lines. number fibers for each switch improves repair installation connection reliability permits configurations that flexibly meet differing requirements. Also the fault monitored with a check signal.
lens.org 参考文章(10)
Thomas E. Stern, Georgios Ellinas, Network switch failure restoration ,(1999)
W. John Tomlinson, Krishna Bala, John Gamelin, Optical matrix protection system ,(1999)
W. John Tomlinson, Krishna Bala, Protection for mems cross-bar switch ,(2000)
Sahabettin Can Demiray, Dale Lee Krisher, Raymond Eugene Tyrrell, A distributed control methodology and mechanism for implementing automatic protection switching ,(1993)
John Lattyak, Joseph F. Svacek, Anthony P. Farinholt, Blaine C. Readler, Survivable network using reverse protection ring ,(1989)
Jian-Yu Liu, Kuang-Yi Wu, System for dealing with faults in an optical link ,(1999)
Nigel Robert Wood, Magnus Öberg, Jonas Hemgren, Protection of wdm-channels ,(1999)
Kouki Sato, Optical line switching system ,(1999)
Steven Clendening, Optical fiber transmission system utilizing a line switched ring to provide protection ,(1997)