Effect of reprocessing on the properties of bisphenol-a polycarbonate
作者： J.I. Eguiazabal , J. Nazabal
DOI: 10.1016/0014-3057(89)90106-7
关键词: Young's modulus 、 Polycarbonate 、 Traction (orthopedics) 、 Impact test 、 Bisphenol A 、 Tensile testing 、 Injection moulding 、 Ultimate tensile strength 、 Materials science 、 Composite material 、 Organic chemistry 、 General Physics and Astronomy 、 Polymers and Plastics
摘要: Abstract The influence of reprocessing by injection moulding on physical properties bisphenol-A polycarbonate has been studied means traction and impact tests. Reprocessing reduces the resistance worsens tensile at break, but no modulus elasticity or yield stress was observed. type reaction taking place during variation molecular weight as a consequence reactions are also discussed.
elsevier.com
sci-hub.se 参考文章(3)
Kent B. Abbås, Reprocessing of thermoplastics. II. Polycarbonate Polymer Engineering & Science. ,vol. 20, pp. 376- 382 ,(1980) , 10.1002/PEN.760200510
T. S. Long, R. J. Sokol, Molding polycarbonate: Moisture degradation effect on physical and chemical properties Polymer Engineering and Science. ,vol. 14, pp. 817- 822 ,(1974) , 10.1002/PEN.760141202
Kent B. Abbås, Degradational effects on bisphenol A polycarbonate extruded at high shear stresses Polymer. ,vol. 22, pp. 836- 841 ,(1981) , 10.1016/0032-3861(81)90025-2