Influence of reprocessing on properties of short fibre-reinforced polycarbonate
作者： A. Chrysostomou , S. Hashemi
DOI: 10.1007/BF00353097
关键词:
摘要: The influence of reprocessing by injection moulding on properties polycarbonate has been studied. It was found that reduces the mean fibre length and increases melt flow index. There no variation in tensile or flexural with number cycles. Fracture toughness, Kc, measured via notched bars indicated material toughness is affected effect more pronounced bending than tension. Strain energy release rate, Gc, not to be significantly Although, as reprocessed, fracture parameters were always lower virgin unprocessed material.
springer.com
harvard.edu
sci-hub.se 参考文章(5)
Kent B. Abbås, Reprocessing of thermoplastics. II. Polycarbonate Polymer Engineering & Science. ,vol. 20, pp. 376- 382 ,(1980) , 10.1002/PEN.760200510
Robert Harold Brown, Fundamentals of Geographic Education Journal of Geography. ,vol. 65, pp. 410- 415 ,(1966) , 10.1080/00221346608985158
Kent B. Abbås, Degradational effects on bisphenol A polycarbonate extruded at high shear stresses Polymer. ,vol. 22, pp. 836- 841 ,(1981) , 10.1016/0032-3861(81)90025-2
J.I. Eguiazabal, J. Nazabal, Effect of reprocessing on the properties of bisphenol-a polycarbonate European Polymer Journal. ,vol. 25, pp. 891- 893 ,(1989) , 10.1016/0014-3057(89)90106-7
E. Plati, J. G. Williams, The determination of the fracture parameters for polymers in impact Polymer Engineering and Science. ,vol. 15, pp. 470- 477 ,(1975) , 10.1002/PEN.760150611