Study on Fabrication and Corrosion Resistance of Ni-Based Alloy Coating on P110 Steel by Electro Spark Deposition

作者: Naiming Lin , Maolin Li , Jiaojuan Zou , Xiaoguang Wang , Bin Tang

DOI: 10.1007/S11665-012-0415-9

关键词: CorrosionCoatingScanning electron microscopeMicrostructureMetallurgyFabricationCasingDielectric spectroscopyElectrochemistryMaterials science

摘要: In this study, a Ni-based alloy coating has been fabricated on P110 oil casing tube steel (P110 steel) surface by electro spark deposition (ESD) process, aiming to improve the latter’s corrosion resistance and increase life in operation. Scanning electron microscope (SEM), energy dispersive x-ray spectrometer (EDS), diffraction (XRD) were used investigate morphology/composition, cross-sectional microstructure, phase constitutions of ESD coating. Electrochemical experiments, including open-circuit potential (OCP), potentiodynamic polarization, electrochemical impedance spectroscopy (EIS) carried out simulated oilfield brine stratum water examine anticorrosion property The results revealed that was continuous compact exhibited higher OCPs, charge transfer resistance, lower current densities than uncoated selected media.

参考文章(19)
Nai-ming Lin, Fa-qin Xie, Jun Zhou, Tao Zhong, Xiang-qing Wu, Wei Tian, Microstructures and wear resistance of chromium coatings on P110 steel fabricated by pack cementation Journal of Central South University of Technology. ,vol. 17, pp. 1155- 1162 ,(2010) , 10.1007/S11771-010-0612-3
Guo-xian Zhao, Xiang-hong Lu, Jian-min Xiang, Yong Han, Formation characteristic of CO2 corrosion product layer of P110 steel investigated by SEM and electrochemical techniques Journal of Iron and Steel Research International. ,vol. 16, pp. 89- 94 ,(2009) , 10.1016/S1006-706X(09)60067-4
Dongyan Liu, Wei Gao, Zhengwei Li, Haifeng Zhang, Zhuangqi Hu, Electro-spark deposition of Fe-based amorphous alloy coatings Materials Letters. ,vol. 61, pp. 165- 167 ,(2007) , 10.1016/J.MATLET.2006.04.042
Y He, H Pang, H Qi, D Wang, Z Li, W Gao, Micro-crystalline Fe–Cr–Ni–Al–Y2O3 ODS alloy coatings produced by high frequency electric-spark deposition Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 334, pp. 179- 186 ,(2002) , 10.1016/S0921-5093(01)01805-6
Cuilian Wen, Shaokang Guan, Li Peng, Chenxing Ren, Xiang Wang, Zhonghua Hu, Characterization and degradation behavior of AZ31 alloy surface modified by bone-like hydroxyapatite for implant applications Applied Surface Science. ,vol. 255, pp. 6433- 6438 ,(2009) , 10.1016/J.APSUSC.2008.09.078
Ailan Fan, Lin Qin, Linhai Tian, Bin Tang, Corrosion resistance of Molybdenum Nitride modified Ti6Al4V alloy in HCl solution Journal of Wuhan University of Technology-Mater. Sci. Ed.. ,vol. 23, pp. 358- 361 ,(2008) , 10.1007/S11595-007-3358-5
Hongbing Liu, Jie Tao, Jiang Xu, Zhaofeng Chen, Qiang Gao, Corrosion and tribological behaviors of chromium oxide coatings prepared by the glow-discharge plasma technique Surface & Coatings Technology. ,vol. 204, pp. 28- 36 ,(2009) , 10.1016/J.SURFCOAT.2009.06.020
Ning Liu, Jianli Wang, Lidong Wang, Yaoming Wu, Limin Wang, Electrochemical corrosion behavior of Mg-5Al-0.4Mn-xNd in NaCl solution Corrosion Science. ,vol. 51, pp. 1328- 1333 ,(2009) , 10.1016/J.CORSCI.2009.03.019
Haiyan Yang, Xingwu Guo, Guohua Wu, Shaohua Wang, Wenjiang Ding, Continuous intermetallic compounds coatings on AZ91D Mg alloy fabricated by diffusion reaction of Mg–Al couples Surface & Coatings Technology. ,vol. 205, pp. 2907- 2913 ,(2011) , 10.1016/J.SURFCOAT.2010.10.066