High flux boiling in low flow rate, low pressure drop mini-channel and micro-channel heat sinks
作者： M.B. Bowers , I. Mudawar
DOI: 10.1016/0017-9310(94)90103-1
关键词: Boiling 、 Materials science 、 Mechanics 、 Pressure drop 、 Heat flux 、 Heat sink 、 Heat transfer 、 Subcooling 、 Critical heat flux 、 Mass flow 、 Thermodynamics
摘要: … single phase flow in micro-channels where pressure losses … for equal channel diameters of single-phase heat sinks nor the … the total pressure drop was determined to be the two-phase …
harvard.edu
elsevier.com
sci-hub.se 参考文章(8)
Alan T. McDonald, Robert W. Fox, Introduction to fluid mechanics ,(1968)
Y. Katto, A generalized correlation of critical heat flux for the forced convection boiling in vertical uniformly heated round tubes—a supplementary report International Journal of Heat and Mass Transfer. ,vol. 22, pp. 783- 794 ,(1979) , 10.1016/0017-9310(79)90017-6
Y. Katto, A generalized correlation of critical heat flux for the forced convection boiling in vertical uniformly heated round tubes International Journal of Heat and Mass Transfer. ,vol. 21, pp. 1527- 1542 ,(1978) , 10.1016/0017-9310(78)90009-1
G.M. Lazarek, S.H. Black, Evaporative heat transfer, pressure drop and critical heat flux in a small vertical tube with R-113 International Journal of Heat and Mass Transfer. ,vol. 25, pp. 945- 960 ,(1982) , 10.1016/0017-9310(82)90070-9
Y. Katto, An analysis of the effect of inlet subcooling on critical heat flux of forced convection boiling in vertical uniformly heated tubes International Journal of Heat and Mass Transfer. ,vol. 22, pp. 1567- 1575 ,(1979) , 10.1016/0017-9310(79)90136-4
D.B. Tuckerman, R.F.W. Pease, High-performance heat sinking for VLSI IEEE Electron Device Letters. ,vol. 2, pp. 126- 129 ,(1981) , 10.1109/EDL.1981.25367
John R. Thome, John G. Collier, Convective Boiling and Condensation ,(1972)
V.K. Dhir, J. Weede, Experimental study of the enhancement of critical heat flux using tangential flow injection HTD (Publ.) (Am. Soc. Mech. Eng.); (United States). ,(1983)