Comparative Research on the Grindability of Ti-6Al-4V and PTMCs with WA Wheel and CBN Wheel
作者： Biao Zhao , Wen Feng Ding , Qing Miao , Jiu Hua Xu , Zhi Wu Liu
DOI: 10.4028/WWW.SCIENTIFIC.NET/AMR.774-776.1075
关键词: Boron nitride 、 Grinding 、 Specific energy 、 Materials science 、 Titanium alloy 、 Metallurgy 、 Titanium matrix composites 、 Ti 6al 4v 、 General Engineering
摘要: This article studies the effect of process parameters on the grindability of Ti-6Al-4V and particulate reinforced titanium matrix composites (PTMCs) comparatively, using the wheels of white alundum (WA) and cubic boron nitride (CBN) respectively. The processing variables, such as grinding force, grinding temperature, specific energy were investigated in detail. The results indicate that the grinding force and temperature with WA wheels were obviously larger than that of CBN wheels. The specific energy of Ti-6Al-4V and PTMCs decreased gradually with the increase in the maximum underformed chip thickness using the two different wheels.
sci-hub.se 参考文章(8)
Chang Yong Yang, Jiu Hua Xu, Wen Feng Ding, Sheng Ting Tong, Grinding Titanium Alloy with Brazed Monolayer CBN Wheels Key Engineering Materials. pp. 33- 37 ,(2007) , 10.4028/WWW.SCIENTIFIC.NET/KEM.359-360.33
Z. Shi, S. Malkin, Wear of Electroplated CBN Grinding Wheels Journal of Manufacturing Science and Engineering-transactions of The Asme. ,vol. 128, pp. 110- 118 ,(2006) , 10.1115/1.2122987
Amanda McKie, Jami Winzer, Iakovos Sigalas, Mathias Herrmann, Ludwig Weiler, Jürgen Rödel, Nedret Can, Mechanical properties of cBN–Al composite materials Ceramics International. ,vol. 37, pp. 1- 8 ,(2011) , 10.1016/J.CERAMINT.2010.07.034
S. Ghosh, A.B. Chattopadhyay, S. Paul, Modelling of specific energy requirement during high-efficiency deep grinding International Journal of Machine Tools and Manufacture. ,vol. 48, pp. 1242- 1253 ,(2008) , 10.1016/J.IJMACHTOOLS.2008.03.008
Kuang-Hua Fuh, Jen-Sheuan Huang, Thermal analysis of creep-feed grinding Journal of Materials Processing Technology. ,vol. 43, pp. 109- 124 ,(1994) , 10.1016/0924-0136(94)90016-7
Xipeng Xu, Stephen Malkin, Comparison of methods to measure grinding temperatures Journal of Manufacturing Science and Engineering-transactions of The Asme. ,vol. 123, pp. 191- 195 ,(2001) , 10.1115/1.1369358
U. Teicher, K. Künanz, A. Ghosh, A. B. Chattopadhyay, Performance of Diamond and CBN Single-Layered Grinding Wheels in Grinding Titanium Materials and Manufacturing Processes. ,vol. 23, pp. 224- 227 ,(2008) , 10.1080/10426910701860541
H. Noguchi, T. Waida, T. Suto, H. Inoue, Wheel designs for grinding Industrial Diamond Review. ,vol. 50, pp. 133- 136 ,(1990)