An integrated orthognathic surgery system for virtual planning and image-guided transfer without intermediate splint
作者： Dae-Seung Kim , Sang-Yoon Woo , Hoon Joo Yang , Kyung-Hoe Huh , Sam-Sun Lee
DOI: 10.1016/J.JCMS.2014.09.007
关键词: Surgical planning 、 Articulator 、 Virtual planning 、 Orthodontics 、 Image guidance 、 Medicine 、 Splint (medicine) 、 Radiography 、 Displacement (orthopedic surgery) 、 Orthognathic surgery
摘要: Accurate surgical planning and transfer of the in orthognathic surgery are very important achieving a successful outcome with appropriate improvement. Conventionally, paper is performed based on 2D cephalometric radiograph, results expressed using cast models an articulator. We developed integrated system 3D virtual image-guided transfer. The maxillary patients was planned virtually, were transferred to model by image guidance. During planning, displacement reference points confirmed from conventional at each procedure. physical directly through root mean square (RMS) difference between 0.75 ± 0.51 mm for 12 patients. RMS image-guidance 0.78 0.52 mm, which showed no significant surgery. will replace enable without need intermediate splint.
elsevier.com
sci-hub.se 参考文章(47)
Ron Jacobson, David M. Sarver, The predictability of maxillary repositioning in LeFort I orthognathic surgery. American Journal of Orthodontics and Dentofacial Orthopedics. ,vol. 122, pp. 142- 154 ,(2002) , 10.1067/MOD.2002.125576
J.-Y. Choi, K.-G. Song, S.-H. Baek, Virtual model surgery and wafer fabrication for orthognathic surgery International Journal of Oral and Maxillofacial Surgery. ,vol. 38, pp. 1306- 1310 ,(2009) , 10.1016/J.IJOM.2009.06.009
Timothy Turvey, David J. Hall, Leward C. Fish, Bruce N. Epker, Surgical-orthodontic treatment planning for simultaneous mobilization of the maxilla and mandible in the correction of dentofacial deformities Oral Surgery, Oral Medicine, Oral Pathology. ,vol. 54, pp. 491- 498 ,(1982) , 10.1016/0030-4220(82)90185-2
Kyu-Gin Song, Seung-Hak Baek, Comparison of the accuracy of the three-dimensional virtual method and the conventional manual method for model surgery and intermediate wafer fabrication. Oral Surgery Oral Medicine Oral Pathology Oral Radiology and Endodontology. ,vol. 107, pp. 13- 21 ,(2009) , 10.1016/J.TRIPLEO.2008.06.002
Jun Uechi, Miki Okayama, Takanori Shibata, Takeshi Muguruma, Kazuo Hayashi, Kazuhiko Endo, Itaru Mizoguchi, A novel method for the 3-dimensional simulation of orthognathic surgery by using a multimodal image-fusion technique. American Journal of Orthodontics and Dentofacial Orthopedics. ,vol. 130, pp. 786- 798 ,(2006) , 10.1016/J.AJODO.2006.03.025
Yoshihide Mori, Toshio Sugahara, Tateshi Hiraki, Improvement of a Condylar Positioning System for the Mandibular Ramus Sagittal Split Osteotomy Journal of Oral and Maxillofacial Surgery. ,vol. 53, pp. 340- 341 ,(1995) , 10.1016/0278-2391(95)90238-4
Kiyoshi Harada, Yasuhiro Okada, Hideaki Nagura, Shoji Enomoto, A new condylar positioning appliance for two-jaw osteotomies (Le Fort I and sagittal split ramus osteotomy). Plastic and Reconstructive Surgery. ,vol. 98, pp. 363- 365 ,(1996) , 10.1097/00006534-199608000-00026
Robin Seeberger, Gavin Kane, Juergen Hoffmann, Georg Eggers, Accuracy assessment for navigated maxillo-facial surgery using an electromagnetic tracking device Journal of Cranio-maxillofacial Surgery. ,vol. 40, pp. 156- 161 ,(2012) , 10.1016/J.JCMS.2011.03.003
R. Bryan Bell, Michael R. Markiewicz, Computer-Assisted Planning, Stereolithographic Modeling, and Intraoperative Navigation for Complex Orbital Reconstruction: A Descriptive Study in a Preliminary Cohort Journal of Oral and Maxillofacial Surgery. ,vol. 67, pp. 2559- 2570 ,(2009) , 10.1016/J.JOMS.2009.07.098
Edward Ellis, Accuracy of model surgery: Evaluation of an old technique and introduction of a new one Journal of Oral and Maxillofacial Surgery. ,vol. 48, pp. 1161- 1167 ,(1990) , 10.1016/0278-2391(90)90532-7