Experimental investigation of the performance of a Ranque–Hilsch vortex tube with regard to a plug located at the hot outlet
作者： Dincer , K. , Baskaya , S. , Uysal
DOI: 10.1016/J.IJREFRIG.2008.06.002
关键词:
摘要: In this study, effects of position, diameter (5, 6, 7, 8 mm) and angle (30°-180°) a mobile plug, located at the hot outlet side in Ranque-Hilsch Vortex Tube (RHVT), were determined experimentally for best performance. addition to plug parameters, supply pressure (200-420 kPa) number nozzles (2, 4, 6) also studied. The internal (D) vortex tube used experiments was 9 mm; ratio length its (L/D) 15. Four different locations maximum difference temperatures cold streams obtained 5 mm, tip angles 30° 60°, 4 by keeping location far extreme end.
iifiir.org
elsevier.com参考文章(26)
I. L. Khodorkov, N. V. Poshernev, M. A. Zhidkov, The Vortex Tube — a Universal Device for Heating, Cooling, Cleaning, and Drying Gases and Separating Gas Mixtures Chemical and Petroleum Engineering. ,vol. 39, pp. 409- 415 ,(2003) , 10.1023/A:1026336813155
K. Stephan, S. Lin, M. Durst, F. Huang, D. Seher, An investigation of energy separation in a vortex tube International Journal of Heat and Mass Transfer. ,vol. 26, pp. 341- 348 ,(1983) , 10.1016/0017-9310(83)90038-8
M.H. Saidi, M.S. Valipour, Experimental modeling of vortex tube refrigerator Applied Thermal Engineering. ,vol. 23, pp. 1971- 1980 ,(2003) , 10.1016/S1359-4311(03)00146-7
Boye Ahlborn, Stuart Groves, Secondary flow in a vortex tube Fluid Dynamics Research. ,vol. 21, pp. 73- 86 ,(1997) , 10.1016/S0169-5983(97)00003-8
M.H. Saidi, M.R. Allaf Yazdi, Exergy model of a vortex tube system with experimental results Energy. ,vol. 24, pp. 625- 632 ,(1999) , 10.1016/S0360-5442(98)00076-0
Sh.A. Piralishvili, V.M. Polyaev, Flow and thermodynamic characteristics of energy separation in a double-circuit vortex tube — An experimental investigation Experimental Thermal and Fluid Science. ,vol. 12, pp. 399- 410 ,(1996) , 10.1016/0894-1777(95)00122-0
W. Fröhlingsdorf, H. Unger, Numerical investigations of the compressible flow and the energy separation in the Ranque-Hilsch vortex tube International Journal of Heat and Mass Transfer. ,vol. 42, pp. 415- 422 ,(1999) , 10.1016/S0017-9310(98)00191-4
K. Dincer, S. Tasdemir, S. Baskaya, B.Z. Uysal, Modeling of the effects of length to diameter ratio and nozzle number on the performance of counterflow Ranque–Hilsch vortex tubes using artificial neural networks Applied Thermal Engineering. ,vol. 28, pp. 2380- 2390 ,(2008) , 10.1016/J.APPLTHERMALENG.2008.01.016
H.M. Skye, G.F. Nellis, S.A. Klein, Comparison of CFD analysis to empirical data in a commercial vortex tube International Journal of Refrigeration-revue Internationale Du Froid. ,vol. 29, pp. 71- 80 ,(2006) , 10.1016/J.IJREFRIG.2005.05.004
N.F. Aljuwayhel, G.F. Nellis, S.A. Klein, Parametric and internal study of the vortex tube using a CFD model International Journal of Refrigeration-revue Internationale Du Froid. ,vol. 28, pp. 442- 450 ,(2005) , 10.1016/J.IJREFRIG.2004.04.004