Optimization of the high-performance multi-crystalline silicon solidification process by insulation partition design using transient global simulations

作者: Zhiyong Wu , Genxiang Zhong , Zhaoyu Zhang , Xucheng Zhou , Zixu Wang

DOI: 10.1016/J.JCRYSGRO.2015.05.021

关键词:

摘要: Abstract A transient global model was established to investigate the effect of raise velocities partition block on crystal growth rate, crystal–melt (C–M) interface and thermal stress distribution during solidification process. The simulation results showed that among different block, initially slowly raising then rapidly most favorable for slightly convex C–M low were obtained, a fast rate also achieved. Thus, this design implemented in casting experiments, experimental indicated beneficial optimizing average conversion efficiencies high-performance multi-crystalline silicon solar cells about 0.13% higher with (18.18%) than fixed (18.05%).

参考文章(14)
Y. M. Yang, A. Yu, B. Hsu, W. C. Hsu, A. Yang, C. W. Lan, Development of high‐performance multicrystalline silicon for photovoltaic industry Progress in Photovoltaics. ,vol. 23, pp. 340- 351 ,(2015) , 10.1002/PIP.2437
Changlin Ding, Meiling Huang, Genxiang Zhong, Liang Ming, Xinming Huang, A design of crucible susceptor for the seeds preservation during a seeded directional solidification process Journal of Crystal Growth. ,vol. 387, pp. 73- 80 ,(2014) , 10.1016/J.JCRYSGRO.2013.08.039
Wencheng Ma, Genxiang Zhong, Lei Sun, Qinghua Yu, Xinming Huang, Lijun Liu, Influence of an insulation partition on a seeded directional solidification process for quasi-single crystalline silicon ingot for high-efficiency solar cells Solar Energy Materials and Solar Cells. ,vol. 100, pp. 231- 238 ,(2012) , 10.1016/J.SOLMAT.2012.01.024
Xu Ma, Lili Zheng, Hui Zhang, Bo Zhao, Cheng Wang, Fenghua Xu, Thermal system design and optimization of an industrial silicon directional solidification system Journal of Crystal Growth. ,vol. 318, pp. 288- 292 ,(2011) , 10.1016/J.JCRYSGRO.2010.10.102
Xin Gu, Xuegong Yu, Kuanxin Guo, Lin Chen, Dong Wang, Deren Yang, Seed-assisted cast quasi-single crystalline silicon for photovoltaic application: Towards high efficiency and low cost silicon solar cells Solar Energy Materials and Solar Cells. ,vol. 101, pp. 95- 101 ,(2012) , 10.1016/J.SOLMAT.2012.02.024
Didi Zhu, Liang Ming, Meiling Huang, Zhaoyu Zhang, Xinming Huang, Seed-assisted growth of high-quality multi-crystalline silicon in directional solidification Journal of Crystal Growth. ,vol. 386, pp. 52- 56 ,(2014) , 10.1016/J.JCRYSGRO.2013.09.051
Andrés Black, Juan Medina, Axa Piñeiro, Ernesto Dieguez, Optimizing seeded casting of mono-like silicon crystals through numerical simulation Journal of Crystal Growth. ,vol. 353, pp. 12- 16 ,(2012) , 10.1016/J.JCRYSGRO.2012.04.033
Xiaofang Qi, Wenhan Zhao, Lijun Liu, Yang Yang, Genxiang Zhong, Xinming Huang, Optimization via simulation of a seeded directional solidification process for quasi-single crystalline silicon ingots by insulation partition design Journal of Crystal Growth. ,vol. 398, pp. 5- 12 ,(2014) , 10.1016/J.JCRYSGRO.2014.04.011
Jiuan Wei, Hui Zhang, Lili Zheng, Chenlei Wang, Bo Zhao, None, Modeling and improvement of silicon ingot directional solidification for industrial production systems Solar Energy Materials and Solar Cells. ,vol. 93, pp. 1531- 1539 ,(2009) , 10.1016/J.SOLMAT.2009.04.001