Numerical Analysis and Experimental Investigation of Energy Partition and Heat Transfer in Grinding
作者： Lei Zhang
DOI: 10.5772/52999
关键词:
摘要: © 2012 Zhang, licensee InTech. This is an open access chapter distributed under the terms of Creative Commons Attribution License (http://creativecommons.org/licenses/by/3.0), which permits unrestricted use, distribution, and reproduction in any medium, provided original work properly cited. Numerical Analysis Experimental Investigation Energy Partition Heat Transfer Grinding
intechopen.com
sci-hub.se 参考文章(16)
I. Zarudi, L. C. Zhang, Modelling the structure changes in quenchable steel subjected to grinding Journal of Materials Science. ,vol. 37, pp. 4333- 4341 ,(2002) , 10.1023/A:1020652519141
I. Zarudi, L. C. Zhang, Mechanical property improvement of quenchable steel by grinding Journal of Materials Science. ,vol. 37, pp. 3935- 3943 ,(2002) , 10.1023/A:1019671926384
Adrienne S. Lavine, An exact solution for surface temperature in down grinding International Journal of Heat and Mass Transfer. ,vol. 43, pp. 4447- 4456 ,(2000) , 10.1016/S0017-9310(00)00024-7
Ichiro Inasaki, Dimitrov, Rowe, , Brian, Marinescu, , Ioan, Boris, Tribology of Abrasive Machining Processes ,(2012)
Lei Zhang, Wen Bo Bi, Ru Bo Zhang, An Approximate Solution of Energy Partition in Grind-Hardening Process Advanced Materials Research. ,vol. 135, pp. 298- 302 ,(2010) , 10.4028/WWW.SCIENTIFIC.NET/AMR.135.298
Gui Cheng Wang, Ju Dong Liu, Hong Jie Pei, Z.H. Jia, Li Jie Ma, Study on Forming Mechanism of Surface Hardening in Two-Pass Grinding 40Cr Steel Key Engineering Materials. pp. 588- 592 ,(2006) , 10.4028/WWW.SCIENTIFIC.NET/KEM.304-305.588
Lei Zhang, Pei Qi Ge, Wen Bo Bi, Qian Zhang, Experiment and Simulation on Residual Stress of Surface Hardened Layer in Grind-Hardening Solid State Phenomena. ,vol. 175, pp. 166- 170 ,(2011) , 10.4028/WWW.SCIENTIFIC.NET/SSP.175.166
Azli Yahya, Andromeda Trias, Minhat Ade Erawan, Khamis Nor Hisham, Kamal Khalil, Muhammad Arif Abdul Rahim, Comparison Studies of Electrical Discharge Machining (EDM) Process Model for Low Gap Current Advanced Materials Research. ,vol. 433-440, pp. 650- 654 ,(2012) , 10.4028/WWW.SCIENTIFIC.NET/AMR.433-440.650
L. Zhang, Pei Qi Ge, J.F. Meng, J.H. Cheng, M. Wang, New Heat Flux Model in Surface Grinding Materials Science Forum. pp. 298- 301 ,(2004) , 10.4028/WWW.SCIENTIFIC.NET/MSF.471-472.298
E. Brinksmeier, T. Brockhoff, Utilization of Grinding Heat as a New Heat Treatment Process CIRP Annals. ,vol. 45, pp. 283- 286 ,(1996) , 10.1016/S0007-8506(07)63064-9