Analysis of transformed fifth order polynomial curve for the contraction of wind tunnel by using OpenFOAM
作者： R Lakshman , Ranjan Basak
DOI: 10.1088/1757-899X/377/1/012048
关键词:
摘要: Contraction is the vital part in wind tunnel hence designing of contraction having greater interest among researchers. Bell and Mehta proposed a fifth order polynomial for design was widely accepted designers. Daniel Brassard transformed to provide better results by making radius at inlet higher than outlet. In this paper analysis investigated using open source CFD tool OpenFOAM. Analysis basically taken considering uniformity air flow, wall shear stress distribution turbulence intensity outlet mid vertical plane test section. From it found that model compared untransformed one terms intensity.
harvard.edu
sci-hub.se 参考文章(13)
JE Sargison, GJ Walker, R Rossi, Design and calibration of a wind tunnel with a two dimensional contraction The Fifteenth Australasian Fluid Mechanics Conference. pp. 0- 0 ,(2004)
Louis Cattafesta, Chris Bahr, Jose Mathew, Fundamentals of Wind‐Tunnel Design Encyclopedia of Aerospace Engineering. ,(2010) , 10.1002/9780470686652.EAE532
James H. Bell, Rabindra D. Mehta, Contraction Design for Small Low-Speed Wind Tunnels NASA STI/Recon Technical Report N. ,vol. 89, pp. 13753- ,(1988)
M. N. Mikhail, Optimum Design of Wind Tunnel Contractions AIAA Journal. ,vol. 17, pp. 471- 477 ,(1979) , 10.2514/3.61157
D. Brassard, M. Ferchichi, Transformation of a polynomial for a contraction wall profile Journal of Fluids Engineering-transactions of The Asme. ,vol. 127, pp. 183- 185 ,(2005) , 10.1115/1.1852492
T. Wolf, Design of a variable contraction for a full-scale automotive wind tunnel Journal of Wind Engineering and Industrial Aerodynamics. ,vol. 56, pp. 1- 21 ,(1995) , 10.1016/0167-6105(94)00010-B
Dale S. Dolan, Danny Zepeda, Taufik Taufik, Development of wind tunnel for laboratory wind turbine testing north american power symposium. pp. 1- 5 ,(2011) , 10.1109/NAPS.2011.6025188
María Rodríguez Lastra, Jesús Manuel Fernández Oro, Mónica Galdo Vega, Eduardo Blanco Marigorta, Carlos Santolaria Morros, Novel design and experimental validation of a contraction nozzle for aerodynamic measurements in a subsonic wind tunnel Journal of Wind Engineering and Industrial Aerodynamics. ,vol. 118, pp. 35- 43 ,(2013) , 10.1016/J.JWEIA.2013.04.008
A.S. Abdelhamed, Y.El-S. Yassen, M.M. ElSakka, Design optimization of three dimensional geometry of wind tunnel contraction Ain Shams Engineering Journal. ,vol. 6, pp. 281- 288 ,(2015) , 10.1016/J.ASEJ.2014.09.008
Johan Groth, Arne V. Johansson, TURBULENCE REDUCTION BY SCREENS Journal of Fluid Mechanics. ,vol. 197, pp. 139- 155 ,(1988) , 10.1017/S0022112088003209