Fabrication of Al-Sn Composites from Direct Recycling Aluminium Alloy 6061
作者： Nur Azam Badarulzaman , Siti Rodiah Karim , Mohd Amri Lajis
DOI: 10.4028/WWW.SCIENTIFIC.NET/AMM.465-466.1003
关键词:
摘要: Solid-state direct conversion method of recycled aluminium 6061 alloy to produce metal-metal composites was studied by using collected recycle chip. Different volume percent stannum (Sn) matrix attempt the tensile strength and surface integrity product. Constant pressure used implement cold forging process with constant sintering temperature. Single size chip had been which 2 mm length as suggested. The optimum result yield ultimate is 3 Pa 8.3 for 20 vol% Sn composition. Analysis shows that beyond resulted in decreased.
sci-hub.se 参考文章(12)
Rees D Rawlings, Frank L Matthews, Composite materials : engineering and science Published in <b>1994</b> in London by Chapman and Hall. ,(1994)
K. J. Martchek, The Importance of Recycling to the Environmental Profile of Metal Products John Wiley & Sons, Inc.. pp. 19- 28 ,(2013) , 10.1002/9781118788073.CH2
J Gronostajski, A Matuszak, The recycling of metals by plastic deformation: an example of recycling of aluminium and its alloys chips Journal of Materials Processing Technology. ,vol. 92, pp. 35- 41 ,(1999) , 10.1016/S0924-0136(99)00166-1
M. Samuel, A new technique for recycling aluminium scrap Journal of Materials Processing Technology. ,vol. 135, pp. 117- 124 ,(2003) , 10.1016/S0924-0136(02)01133-0
Gerald S. Cole, Issues that Influence Magnesium's Use in the Automotive Industry Materials Science Forum. pp. 43- 50 ,(2003) , 10.4028/WWW.SCIENTIFIC.NET/MSF.419-422.43
X. Liu, M.Q. Zeng, Y. Ma, M. Zhu, Melting behavior and the correlation of Sn distribution on hardness in a nanostructured Al–Sn alloy Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 506, pp. 1- 7 ,(2009) , 10.1016/J.MSEA.2008.12.054
J. Gronostajski, H. Marciniak, A. Matuszak, New methods of aluminium and aluminium-alloy chips recycling Journal of Materials Processing Technology. ,vol. 106, pp. 34- 39 ,(2000) , 10.1016/S0924-0136(00)00634-8
W. Chmura, J. Gronostajski, Mechanical and tribological properties of aluminium-base composites produced by the recycling of chips Journal of Materials Processing Technology. ,vol. 106, pp. 23- 27 ,(2000) , 10.1016/S0924-0136(00)00632-4
Iddo K. Wernick, Nickolas J. Themelis, RECYCLING METALS FOR THE ENVIRONMENT Annual Review of Energy and The Environment. ,vol. 23, pp. 465- 497 ,(1998) , 10.1146/ANNUREV.ENERGY.23.1.465
A. D. Latha, I. Rajendran, T. Rameshkumar, Investigation on the Mechanical and Tribological Properties of Aluminium-Tin Based Plain Bearing Material Tribology in Industry. ,vol. 32, pp. 3- 10 ,(2010)