The effect of feed rate and of tool nose radius on the roughness of oblique finish turned surfaces
作者： Petros G. Petropoulos
DOI: 10.1016/0043-1648(73)90019-7
关键词:
摘要: Abstract The influence of feed rate and tool nose radius on surface roughness in oblique finish turning a carbon steel is studied for both sharp worn cutting tools. A comparison between the experimentally determined values theoretical computed from eqns. (1) (2) performed. Linear regression analysis applied to experimental data obtained an attempt establish laws relating expression s 2 R , prediction purposes.
elsevier.com
sci-hub.se 参考文章(9)
Milton Clayton Shaw, Metal cutting principles ,(1960)
K.V. Olsen, Surface roughness on turned steel components and the relevant mathematical analysis Production Engineer. ,vol. 47, pp. 593- 606 ,(1968) , 10.1049/TPE.1968.0098
Vladimir Šolaja, Wear of carbide tools and surface finish generated in finish turning of steel Wear. ,vol. 2, pp. 40- 58 ,(1958) , 10.1016/0043-1648(58)90339-9
PETROS G. PETROPOULOS, Statistical basis for surface roughness assessment in oblique finish turning of steel components International Journal of Production Research. ,vol. 12, pp. 345- 360 ,(1974) , 10.1080/00207547408919560
Amitabha Bhattacharyya, Regression Analysis for Predicting Surface Finish and Its Application in the Determination of Optimum Machining Conditions Journal of Engineering for Industry. ,vol. 92, pp. 711- 714 ,(1970) , 10.1115/1.3427835
K. L. Chandiramani, N. H. Cook, Investigations on the Nature of Surface Finish and Its Variation With Cutting Speed Journal of Engineering for Industry. ,vol. 86, pp. 134- 140 ,(1964) , 10.1115/1.3670471
A.I. ISAEV, INFLUENCE OF THE RIGIDITY OF THE MACHINE-WORKPIECE-TOOL SYSTEM ON THE ROUGHNESS OF MACHINED SURFACE Advances in Machine Tool Design and Research 1967. pp. 75- 81 ,(1968) , 10.1016/B978-0-08-003491-1.50007-1
Bernard Ostle, Statistics in research ,(1969)
Paul Gerhard Hoel, Elementary Statistics ,(1971)