Engine Performance and Emission of Compression Ignition Engine Fuelled With Emulsified Biodiesel-Water
作者： W N Maawa , R Mamat , G Najafi , O Majeed Ali , A Aziz
DOI: 10.1088/1757-899X/100/1/012061
关键词:
摘要: The depletion of fossil fuel and environmental pollution has become world crucial issues in current era. Biodiesel-water emulsion is one many possible approaches to reduce emissions. In this study, emulsified biodiesel with 4%, 6% 8% water contents were prepared be used as a direct injection compression ignition engine. performance indicator such brake power, specific consumption (BSFC) thermal efficiency (BTE) emissions NOx particulate matter (PM) investigated. engine was set at constant speed 2500 rpm load from 20% 60%. All the results compared B5 (blend 95% petroleum diesel 5% palm oil biodiesel) biodiesel. At low load, BSFC decrease by 12.75% 4% ratio decreased 1.5% ratio. However, increases 17.19% increasing B5. Furthermore, there no significant power BTE 60% load. For 40% some variance regarding BTE. Significant reduction PM 73.87% 20.00% respectively achieved 8%. Overall, it observed that biodiesel-water an appropriate alternative method
harvard.edu
sci-hub.se 参考文章(18)
Youzhi Liu, Weizhou Jiao, Guisheng Qi, Preparation and properties of methanol–diesel oil emulsified fuel under high-gravity environment Renewable Energy. ,vol. 36, pp. 1463- 1468 ,(2011) , 10.1016/J.RENENE.2010.11.007
Cherng-Yuan Lin, Li-Wei Chen, Comparison of fuel properties and emission characteristics of two- and three-phase emulsions prepared by ultrasonically vibrating and mechanically homogenizing emulsification methods Fuel. ,vol. 87, pp. 2154- 2161 ,(2008) , 10.1016/J.FUEL.2007.12.017
Pascal Ndayishimiye, Mohand Tazerout, Use of palm oil-based biofuel in the internal combustion engines: Performance and emissions characteristics Energy. ,vol. 36, pp. 1790- 1796 ,(2011) , 10.1016/J.ENERGY.2010.12.046
Amir Aziz, Asraf Jusoh, Rizalman Mamat, A. Adam Abdullah, Effect of Water Content and Tween 80 to the Stability of Emulsified Biodiesel Applied Mechanics and Materials. pp. 191- 195 ,(2013) , 10.4028/WWW.SCIENTIFIC.NET/AMM.465-466.191
Masjuki Hj Hassan, Md Abul Kalam, An Overview of Biofuel as a Renewable Energy Source: Development and Challenges Procedia Engineering. ,vol. 56, pp. 39- 53 ,(2013) , 10.1016/J.PROENG.2013.03.087
Gonglun Chen, Daniel Tao, An experimental study of stability of oil-water emulsion Fuel Processing Technology. ,vol. 86, pp. 499- 508 ,(2005) , 10.1016/J.FUPROC.2004.03.010
K.A. Subramanian, A comparison of water–diesel emulsion and timed injection of water into the intake manifold of a diesel engine for simultaneous control of NO and smoke emissions Energy Conversion and Management. ,vol. 52, pp. 849- 857 ,(2011) , 10.1016/J.ENCONMAN.2010.08.010
A. Alahmer, J. Yamin, A. Sakhrieh, M.A. Hamdan, Engine performance using emulsified diesel fuel Energy Conversion and Management. ,vol. 51, pp. 1708- 1713 ,(2010) , 10.1016/J.ENCONMAN.2009.11.044
Dina Darshini, Puneet Dwivedi, Klaus Glenk, Capturing stakeholders´ views on oil palm-based biofuel and biomass utilisation in Malaysia Energy Policy. ,vol. 62, pp. 1128- 1137 ,(2013) , 10.1016/J.ENPOL.2013.07.017
Ali Alahmer, Influence of using emulsified diesel fuel on the performance and pollutants emitted from diesel engine Energy Conversion and Management. ,vol. 73, pp. 361- 369 ,(2013) , 10.1016/J.ENCONMAN.2013.05.012