A novel high straining process for bulk materials-The development of a multipass forging system by compression along three axes
作者： C. Desrayaud , S. Ringeval , S. Girard , J.H. Driver
DOI: 10.1016/J.JMATPROTEC.2005.09.015
关键词:
摘要: … obtained by multipass forging which … pass, a strain of 0.4 was applied, the sample dimensional ratio did not change while the loading direction was changed by 90 from pass to pass. …
elsevier.com
sci-hub.se 参考文章(7)
Betzalel Avitzur, Metal forming: Processes and analysis ,(1979)
V.M. Segal, Materials processing by simple shear Materials Science and Engineering: A. ,vol. 197, pp. 157- 164 ,(1995) , 10.1016/0921-5093(95)09705-8
A Belyakov, T Sakai, H Miura, Microstructure and deformation behaviour of submicrocrystalline 304 stainless steel produced by severe plastic deformation Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 319, pp. 867- 871 ,(2001) , 10.1016/S0921-5093(00)02028-1
Minoru Furukawa, Zenji Horita, Minoru Nemoto, Terence G. Langdon, The use of severe plastic deformation for microstructural control Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 324, pp. 82- 89 ,(2002) , 10.1016/S0921-5093(01)01288-6
R.Z Valiev, R.K Islamgaliev, I.V Alexandrov, Bulk nanostructured materials from severe plastic deformation Progress in Materials Science. ,vol. 45, pp. 103- 189 ,(2000) , 10.1016/S0079-6425(99)00007-9
A Belyakov, K Tsuzaki, H Miura, T Sakai, Effect of initial microstructures on grain refinement in a stainless steel by large strain deformation Acta Materialia. ,vol. 51, pp. 847- 861 ,(2003) , 10.1016/S1359-6454(02)00476-7
J.H. Schmitt, E.L. Shen, J.L. Raphanel, A parameter for measuring the magnitude of a change of strain path: Validation and comparison with experiments on low carbon steel International Journal of Plasticity. ,vol. 10, pp. 535- 551 ,(1994) , 10.1016/0749-6419(94)90013-2