Biocompatibility of bismuth silicate coatings deposited on 316L stainless steel by sol-gel process
作者： Jorge Hernando Bautista Ruiz , Jhon Jairo Olaya Flórez , Willian Arnulfo Aperador Chaparro , ,
DOI: 10.17533/UDEA.REDIN.N84A04
关键词:
摘要: Bismuth silicate, (BSO) thin films have been fabricated by sol–gel process. The stable sol was synthesized using bismuth nitrate (III) pentahydrate and tetraethyl orthosilicate (TEOS). were deposited spin-coating at 1500 rpm on Stainless Steel 316L. characterized Atomic Force Microscopy (AFM), Scanning Electron (SEM), X-ray diffraction (XRD) besides the measured of thickness. This study aimed to evaluate cell adhesion cellular proliferation osteoblast cells BSO substrate 316L MTT assay. It is concluded that growth osteoblasts homogeneous in surface coatings indicating medium offered does not present active cytotoxicity exceed large number level compared Steel.
sci-hub.st 参考文章(30)
A. Nazeri, P.P. Trzaskoma-Paulette, D. Bauer, Synthesis and Properties of Cerium and Titanium Oxide Thin Coatings for Corrosion Protection of 304 Stainless Steel Journal of Sol-Gel Science and Technology. ,vol. 10, pp. 317- 331 ,(1997) , 10.1023/A:1018381503008
Xiao Guo Cao, San Ping Jiang, Yun Yong Li, Synthesis and characterization of calcium and iron co-doped lanthanum silicate oxyapatites by sol-gel process for solid oxide fuel cells Journal of Power Sources. ,vol. 293, pp. 806- 814 ,(2015) , 10.1016/J.JPOWSOUR.2015.06.008
M. Oubaha, A. Gorin, C. McDonagh, B. Duffy, R. Copperwhite, Development of a multianalyte optical sol–gel biosensor for medical diagnostic Sensors and Actuators B-chemical. ,vol. 221, pp. 96- 103 ,(2015) , 10.1016/J.SNB.2015.06.012
DDY Setsoafia, P Hing, SC Jung, AK Azad, CM Lim, None, Sol–gel synthesis and characterization of Zn2+ and Mg2+ doped La10Si6O27 electrolytes for solid oxide fuel cells Solid State Sciences. ,vol. 48, pp. 163- 170 ,(2015) , 10.1016/J.SOLIDSTATESCIENCES.2015.08.001
Xiaojing Wang, Mingyuan Lu, Ling Qiu, Han Huang, Dan Li, Huanting Wang, Yi-Bing Cheng, Graphene/titanium carbide composites prepared by sol–gel infiltration and spark plasma sintering Ceramics International. ,vol. 42, pp. 122- 131 ,(2016) , 10.1016/J.CERAMINT.2015.08.017
Zahra Abbasi, Mohammad E. Bahrololoum, Rafat Bagheri, Mohammad H. Shariat, Characterization of the bioactive and mechanical behavior of dental ceramic/sol-gel derived bioactive glass mixtures. Journal of The Mechanical Behavior of Biomedical Materials. ,vol. 54, pp. 115- 122 ,(2016) , 10.1016/J.JMBBM.2015.09.025
Amirhassan Amiri, Solid-phase microextraction-based sol–gel technique Trends in Analytical Chemistry. ,vol. 75, pp. 57- 74 ,(2016) , 10.1016/J.TRAC.2015.10.003
Sam Chehab, Pierre Conflant, Michel Drache, Jean-Claude Boivin, George McDonald, Solid-state reaction pathways of Sillenite-phase formation studied by high-temperature X-ray diffractometry and differential thermal analysis Materials Research Bulletin. ,vol. 38, pp. 875- 897 ,(2003) , 10.1016/S0025-5408(03)00025-4
Asja Veber, Špela Kunej, Danilo Suvorov, Synthesis and microstructural characterization of Bi12SiO20 (BSO) thin films produced by the sol-gel process Ceramics International. ,vol. 36, pp. 245- 250 ,(2010) , 10.1016/J.CERAMINT.2009.07.024
Erwin A Vogler, Structure and reactivity of water at biomaterial surfaces Advances in Colloid and Interface Science. ,vol. 74, pp. 69- 117 ,(1998) , 10.1016/S0001-8686(97)00040-7