Mechanism of burr formation in slot milling Al-alloy
作者： G. Liu , M. Chen , M. Luo
DOI: 10.1504/IJMPT.2008.015896
关键词:
摘要: Burrs are bottleneck of precision machining and automation production. This paper reports the results experiments to investigate mechanism burr formation on feed direction based experimental research in slot milling Al-alloy. Experiments orthogonal with various exit angles oblique cutting have been conducted. Maximum height thickness side measured. The experiment show that friction angle becomes larger angle. size increases up is benefit Al-alloy other light metal.
sci-hub.se 参考文章(5)
Ko Sung-Lim, David A. Dornfeld, Analysis of fracture in burr formation at the exit stage of metal cutting Journal of Materials Processing Technology. ,vol. 58, pp. 189- 200 ,(1996) , 10.1016/0924-0136(95)02124-8
Sung-Lim Ko, David A. Dornfeld, Burr formation and fracture in oblique cutting Journal of Materials Processing Technology. ,vol. 62, pp. 24- 36 ,(1996) , 10.1016/0924-0136(95)02125-6
Ming Chen, Guo Liang Liu, Fang Hong Sun, Xiao Gang Jian, Ren Wei Yuan, Investigation of Chip Formation Mechanism and Surface Integrity in High Speed Milling Titanium Alloy Key Engineering Materials. pp. 489- 496 ,(2003) , 10.4028/WWW.SCIENTIFIC.NET/KEM.233-236.489
O Olvera, G Barrow, Influence of exit angle and tool nose geometry on burr formation in face milling operations Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture. ,vol. 212, pp. 59- 72 ,(1998) , 10.1243/0954405981515509
L. K. Gillespie, P. T. Blotter, The Formation and Properties of Machining Burrs Journal of Engineering for Industry. ,vol. 98, pp. 66- 74 ,(1976) , 10.1115/1.3438875