Influence of exit angle and tool nose geometry on burr formation in face milling operations
作者： O Olvera , G Barrow
关键词:
摘要: AbstractOne of the more important burrs produced in a face milling operation is burr formed on exit edge cutting direction. This present over full length edge...
sagepub.com
sci-hub.se 参考文章(9)
L.K. Gillespie, Burrs produced by end milling ,(1976) , 10.2172/7259917
C. D. Beachem, The effects of crack tip plastic flow directions upon microscopic dimple shapes Metallurgical and Materials Transactions A-physical Metallurgy and Materials Science. ,vol. 6, pp. 377- 383 ,(1975) , 10.1007/BF02667293
Ko Sung-Lim, David A. Dornfeld, Analysis of fracture in burr formation at the exit stage of metal cutting Journal of Materials Processing Technology. ,vol. 58, pp. 189- 200 ,(1996) , 10.1016/0924-0136(95)02124-8
A.J. Pekelharing, The Exit Failure of Cemented Carbide Face Milling Cutters Part I — Fundamentals and Phenomenae CIRP Annals. ,vol. 33, pp. 47- 50 ,(1984) , 10.1016/S0007-8506(07)61377-8
Gwo-Lianq Chern, David A. Dornfeld, Burr/Breakout Model Development and Experimental Verification Journal of Engineering Materials and Technology-transactions of The Asme. ,vol. 118, pp. 201- 206 ,(1996) , 10.1115/1.2804887
Keiji OKUSHIMA, Kiyoshi MINATO, On the Behavior of Chip in Steel Cutting Jsme International Journal Series B-fluids and Thermal Engineering. ,vol. 2, pp. 58- 64 ,(1959) , 10.1299/JSME1958.2.58
Sung-Lim Ko, David A. Dornfeld, A Study on Burr Formation Mechanism Journal of Engineering Materials and Technology-transactions of The Asme. ,vol. 113, pp. 75- 87 ,(1991) , 10.1115/1.2903385
H T Young, P Mathew, P L B Oxley, Allowing for Nose Radius Effects in Predicting the Chip Flow Direction and Cutting Forces in Bar Turning Proceedings of the Institution of Mechanical Engineers, Part C: Journal of Mechanical Engineering Science. ,vol. 201, pp. 213- 226 ,(1987) , 10.1243/PIME_PROC_1987_201_108_02
O. Olvera, G. Barrow, An experimental study of burr formation in square shoulder face milling International Journal of Machine Tools & Manufacture. ,vol. 36, pp. 1005- 1020 ,(1996) , 10.1016/0890-6955(96)00014-4