Influence of Cure Conditions on the Adhesion of Rubber Compound to Brass-plated Steel Cord. Part II. Cure Time
作者： Gyung Soo Jeon , Gon Seo
DOI: 10.1080/00218460108029627
关键词:
摘要: Abstract The effect of the cure time a rubber compound on adhesion with brass-plated steel cord was investigated. formation, growth and degradation interphase formed between also observed as well formation weak boundary layer in near interphase. With increase from fourth to four times t 90, pull-out force after vulcanization increased significantly up one-half 90 followed by slight then decreased slowly further time. This decrease upon prolonged may be explained severe attached Also, vulcanization, rich ZnS act barrier copper diffusion which is required form sulfide. After thermal aging samples, pul...
sci-hub.se 参考文章(18)
Feng-Bin Li, G.E. Thompson, R.C. Newman, Force modulation atomic force microscopy: background, development and application to electrodeposited cerium oxide films Applied Surface Science. ,vol. 126, pp. 21- 33 ,(1998) , 10.1016/S0169-4332(97)00590-4
M. Munz, H. Sturm, E. Schulz, G. Hinrichsen, The scanning force microscope as a tool for the detection of local mechanical properties within the interphase of fibre reinforced polymers Composites Part A-applied Science and Manufacturing. ,vol. 29, pp. 1251- 1259 ,(1998) , 10.1016/S1359-835X(98)00077-3
Arup K. Chandra, Arabinda Biswas, R. Mukhopadhyay, Anil K. Bhowmick, SEM/EDX studies of the influence of a cobalt adhesion promoter on the interface between rubber skim compounds and tire steel cord Journal of Adhesion Science and Technology. ,vol. 10, pp. 431- 460 ,(1996) , 10.1163/156856196X00526
W.J. van Ooij, A. Kleinhesselink, Application of XPS to the study of polymer-metal interface phenomena Applications of Surface Science. ,vol. 4, pp. 324- 339 ,(1980) , 10.1016/0378-5963(80)90082-3
T. B. Ghosh, A. K. Bhowmick, A. K. Chandra, R. Mukhopadhyay, J. Konar, X-ray photoelectron spectroscopy and Auger electron spectroscopy of the influence of cations and anions of organometallic adhesion promoters on the interface between steel cord and rubber skim compounds Journal of Materials Science. ,vol. 31, pp. 2667- 2676 ,(1996) , 10.1007/BF00687298
Yasuhiro Ishikawa, Effects of Compound Formulation on the Adhesion of Rubber to Brass-Plated Steel Cord Rubber Chemistry and Technology. ,vol. 57, pp. 855- 878 ,(1984) , 10.5254/1.3536045
Gon Seo, Stabilizing the adhesion interphase between rubber compounds and brass film by the addition of resorcinol formaldehyde resin to the rubber Journal of Adhesion Science and Technology. ,vol. 11, pp. 1433- 1445 ,(1997) , 10.1163/156856197X00228
Gyung Soo Jeon, Min Hyeon Han, Gon Seo, Effect of ZnO contents at the surface of brass-plated steel cord on the adhesion property to rubber compound Korean Journal of Chemical Engineering. ,vol. 16, pp. 248- 252 ,(1999) , 10.1007/BF02706844
E.W. Stroup, A. Pungor, V. Hlady, A constant compliance force modulation technique for scanning force microscopy (SFM) imaging of polymer surface elasticity Ultramicroscopy. ,vol. 66, pp. 237- 249 ,(1996) , 10.1016/S0304-3991(96)00090-3
T. Kretzschmar, K. Hummel, F. Hofer, W. Grogger, G. Grubbauer, Investigation of the rubber-metal bonding system by means of analytical electron microscopy and comparison with results of technical tear strength measurements Fresenius Journal of Analytical Chemistry. ,vol. 349, pp. 235- 236 ,(1994) , 10.1007/BF00323292