OPTIMIZATION OF CUTTING PARAMETERS FOR POCKET MILLING ON THE SKIN PLATE IN AL AND AL-LI MATERIALS
作者： Hadi Moradi , None
DOI:
关键词:
摘要: RÉSUMÉ L'objectif de cette étude est d'optimiser des paramètres de coupes pour l'usinage de poche sur une plaque mince en alliage d'aluminium et en alliage d'aluminium-lithium …
参考文章(60)
Rosenberg Ludwig M, Ben Snyder Herman, Chemical milling process and composition ,(1957)
Fu Yin Ma, Li Jinguo, Wu Weiwei, Li Wei, Cai Lijun, Evaluation Method for Milling Machining Deformation of Thin-Walled Structures Advances in Computer Science, Environment, Ecoinformatics, and Education. pp. 468- 473 ,(2011) , 10.1007/978-3-642-23345-6_85
A Senthil Kumar, Andrew Y C Nee, Z J Tao, An Advanced Treatise on Fixture Design and Planning ,(2004)
Joseph R. Davis, Properties and selection : nonferrous alloys and special-purpose materials ASM International. ,(1990)
Thomas Schmitt, High-speed machining of dies and molds ,(1997)
Abdelkarim Ben Mhenni, Christian Mascle, Marek Balazinski, Agility in High Speed Machining: Optimization between Tool and Holder Advances in Integrated Design and Manufacturing in Mechanical Engineering II. pp. 475- 488 ,(2007) , 10.1007/978-1-4020-6761-7_32
Brian Boswell, Mohammad Nazrul Islam, Feasibility Study of Adopting Minimal Quantities of Lubrication for End Milling Aluminium world congress on engineering. pp. 1358- 1362 ,(2012)
Russell J. McDonald, Characterization of delamination in 2099-T861 aluminum-lithium Ph.D. Thesis. ,(2009)
Jean-François Chatelain, Antoine S. Tahan, Jean-François Lalonde, Effect of Residual Stresses Embedded within Workpieces on the Distortion of Parts after Machining ,(2012)
C. Y. Liao, J. K. Wu, Chemical machining of nickel in ferric chloride solution Journal of Materials Science Letters. ,vol. 11, pp. 689- 691 ,(1992) , 10.1007/BF00728908