Repair and Manufacture of High Performance Products for Medicine and Aviation with Laser Technology
作者： M. Milfelner , J. Kopac , M. Balazic
DOI:
关键词:
摘要: High performance products used for special purposes in medicine and aviation are often manufactured from advanced materials such as titanium nickel based alloys. As the most promising effective technology production repair Laser Rapid Prototyping technologies being implemented into practice. Special focus has been orientated Net Shape (LENS) technology. This paper will review State of Art LENS laser present application case studies where is applied to manufacture modern medical implants bone fixation plate jet engine turbine inconel blades
kmutnb.ac.th参考文章(9)
Martin Hedges, Neil Calder, Near Net Shape Rapid Manufacture & Repair by LENS(registered trademark) ,(2006)
F. C. Campbell, Manufacturing technology for aerospace structural materials ,(2006)
Pentti Tengvall, Ingemar Lundström, Physico-chemical considerations of titanium as a biomaterial. Clinical Materials. ,vol. 9, pp. 115- 134 ,(1992) , 10.1016/0267-6605(92)90056-Y
Gary K Lewis, Eric Schlienger, Practical considerations and capabilities for laser assisted direct metal deposition Materials & Design. ,vol. 21, pp. 417- 423 ,(2000) , 10.1016/S0261-3069(99)00078-3
L. N. Lo´pez de Lacalle, J. A. Sa´nchez, A. Lamikiz, A. Celaya, Plasma Assisted Milling of Heat-Resistant Superalloys Journal of Manufacturing Science and Engineering-transactions of The Asme. ,vol. 126, pp. 274- 285 ,(2004) , 10.1115/1.1644548
P. Rangaswamy, M.L. Griffith, M.B. Prime, T.M. Holden, R.B. Rogge, J.M. Edwards, R.J. Sebring, Residual stresses in LENS® components using neutron diffraction and contour method Materials Science and Engineering A-structural Materials Properties Microstructure and Processing. ,vol. 399, pp. 72- 83 ,(2005) , 10.1016/J.MSEA.2005.02.019
Fumio Watari, Atsuro Yokoyama, Mamoru Omori, Toshio Hirai, Hideomi Kondo, Motohiro Uo, Takao Kawasaki, Biocompatibility of materials and development to functionally graded implant for bio-medical application Composites Science and Technology. ,vol. 64, pp. 893- 908 ,(2004) , 10.1016/J.COMPSCITECH.2003.09.005
Dirk A. Hollander, Matthias von Walter, Tobias Wirtz, Richard Sellei, Bernhard Schmidt-Rohlfing, Othmar Paar, Hans-Josef Erli, Structural, mechanical and in vitro characterization of individually structured Ti-6Al-4V produced by direct laser forming. Biomaterials. ,vol. 27, pp. 955- 963 ,(2006) , 10.1016/J.BIOMATERIALS.2005.07.041
A.J. Nitz, Chapter 4 – Bone Injury and Repair Orthopaedic Physical Therapy Secrets (Third Edition). pp. 28- 34 ,(2017) , 10.1016/B978-0-323-28683-1.00004-7