Styrene-butyl acrylate copolymers latexes prepared with different functional monomers and their application as anti-icing coatings
作者： Xubao Jiang , Dong Zou , Xiang Zheng Kong , Xiaoli Zhu , Zhiguo Zhang
DOI: 10.1007/S10965-014-0473-9
关键词:
摘要: Four polymer latexes, including Base latex synthesized using styrene and butyl acrylate as the main monomers, Latex Si prepared with 4.0 wt% of vinyl triethoxysilane, F dodecafluoroheptyl methacrylate D4 8.5 wt% octamethyl cyclotetrasiloxane (D4), were through a semi-continuous emulsion polymerization. Characterization films revealed that water absorption lower than those Latexes Si; whereas their contact angle also smaller other two films. The latexes applied coating onto steel Al metals different forms to evaluate performance in corrosion anti-icing tests. Coated on plates for resistance test, it was found showed poorer performance; made from better performance. In tests, either circular helix coils followed by refrigeration after spray, or stranded power line test an IWT (ice wind tunnel), best performance, lowest two, Si, located between. conducted coated stainless rods used reinforced core. effectiveness quite similar observed transmission lines: highest lowest, although differences magnitude obviously
springer.com
sci-hub.se 参考文章(19)
Jennifer Ayres, W. H. Simendinger, C. M. Balik, Characterization of titanium alkoxide sol-gel systems designed for anti-icing coatings: II. Mass loss kinetics Journal of Coatings Technology and Research. ,vol. 4, pp. 473- 481 ,(2007) , 10.1007/S11998-007-9055-7
Dongmei Yu, Yunhui Zhao, Hui Li, Hengzhi Qi, Bo Li, Xiaoyan Yuan, None, Preparation and evaluation of hydrophobic surfaces of polyacrylate-polydimethylsiloxane copolymers for anti-icing Progress in Organic Coatings. ,vol. 76, pp. 1435- 1444 ,(2013) , 10.1016/J.PORGCOAT.2013.05.036
J.L. Laforte, M.A. Allaire, J. Laflamme, State-of-the-art on power line de-icing Atmospheric Research. ,vol. 46, pp. 143- 158 ,(1998) , 10.1016/S0169-8095(97)00057-4
H. H. G. Jellinek, H. Kachi, S. Kittaka, M. Lee, R. Yokota, Ice releasing block-copolymer coatings Colloid and Polymer Science. ,vol. 256, pp. 544- 551 ,(1978) , 10.1007/BF01639199
Markus Susoff, Konstantin Siegmann, Cornelia Pfaffenroth, Martina Hirayama, Evaluation of icephobic coatings—Screening of different coatings and influence of roughness Applied Surface Science. ,vol. 282, pp. 870- 879 ,(2013) , 10.1016/J.APSUSC.2013.06.073
R.J. Kind, M.G. Potapczuk, A. Feo, C. Golia, A.D. Shah, Experimental and computational simulation of in-flight icing phenomena Progress in Aerospace Sciences. ,vol. 34, pp. 257- 345 ,(1998) , 10.1016/S0376-0421(98)80001-8
G.W. Critchlow, R.E. Litchfield, I. Sutherland, D.B. Grandy, S. Wilson, A review and comparative study of release coatings for optimised abhesion in resin transfer moulding applications International Journal of Adhesion and Adhesives. ,vol. 26, pp. 577- 599 ,(2006) , 10.1016/J.IJADHADH.2005.09.003
Xia Zhang, Yonggang Guo, Zhijun Zhang, Pingyu Zhang, Self-cleaning superhydrophobic surface based on titanium dioxide nanowires combined with polydimethylsiloxane Applied Surface Science. ,vol. 284, pp. 319- 323 ,(2013) , 10.1016/J.APSUSC.2013.07.100
Olivier Parent, Adrian Ilinca, Anti-icing and de-icing techniques for wind turbines: Critical review Cold Regions Science and Technology. ,vol. 65, pp. 88- 96 ,(2011) , 10.1016/J.COLDREGIONS.2010.01.005
A. Dotan, H. Dodiuk, C. Laforte, S. Kenig, The Relationship between Water Wetting and Ice Adhesion Journal of Adhesion Science and Technology. ,vol. 23, pp. 1907- 1915 ,(2009) , 10.1163/016942409X12510925843078