Dynamic recovery during compression testing of monocrystalline NaCl at elevated temperatures

作者: M.A. Przystupa , P. Lin , A.J. Ardell , O. Ajaja

DOI: 10.1016/0025-5416(87)90156-X

关键词:

摘要: Abstract Single crystals of NaCl in a 〈100〉 orientation were tested under compression the constant-strain-rate mode at 873 and 973 K. The evolution dislocation microstructure was studied both temperatures over entire range strains (up to 0.2) using standard etch-pitting techniques. At K flow stress σ slowly increases monotonically with strain even though free density ϱ (the dislocations within subgrains) passes through maximum plastic about 0.02. K, behaves similarly, although nearly steady state is eventually observed; this stage substructure as well remain invariant further straining. It argued that initial increase comparable which occurs on loading sample during creep test. However, since rate test typically much slower than it test, small easier follow. On establishment compatible (approximate) elevated temperatures, recovery produces coarsening network. attendant reduction constant then entirely analogous decrease primary conventional tests.

参考文章(22)
J.L. Adelus, V. Guttmann, V.D. Scott, Effect of prior cold working on the creep of 314 alloy steel Materials Science and Engineering. ,vol. 44, pp. 195- 204 ,(1980) , 10.1016/0025-5416(80)90120-2
A.J Ardell, M.A Przystupa, Dislocation link-length statistics and elevated temperature deformation of crystals☆ Mechanics of Materials. ,vol. 3, pp. 319- 332 ,(1984) , 10.1016/0167-6636(84)90032-2
C.N Ahlquist, W.D Nix, The measurement of internal stresses during creep of al and Al-Mg alloys Acta Metallurgica. ,vol. 19, pp. 373- 385 ,(1971) , 10.1016/0001-6160(71)90105-2
O. Ajaja, A. J. Ardell, Microstructure and transient creep in an austenitic stainless steel Philosophical Magazine. ,vol. 39, pp. 65- 73 ,(1979) , 10.1080/01418617908239276
S. Mendelson, Dislocation Etch Pit Formation in Sodium Chloride Journal of Applied Physics. ,vol. 32, pp. 1579- 1583 ,(1961) , 10.1063/1.1728399
A. Orlová, M. Pahutová, J. čadek, Dislocation structure and applied, effective and internal stress in high-temperature creep of alpha iron Philosophical Magazine. ,vol. 25, pp. 865- 877 ,(1972) , 10.1080/14786437208229309
B. Brenner, A. Luft, The mechanism of work softening in cold-worked molybdenum polycrystals at an elevated temperature Materials Science and Engineering. ,vol. 52, pp. 229- 237 ,(1982) , 10.1016/0025-5416(82)90150-1