Evaluation of calcium titanate as apatite growth promoter.

作者: J. Coreño , O. Coreño

DOI: 10.1002/JBM.A.30447

关键词:

摘要: Calcium titanate (CaTiO3, perovskite) has been used to determine its apatite nucleation ability and propose a possible initial step. Measurements of calcium leaching from the surface phosphate adsorption experiments were carried out separately by using commercial suspensions at room temperature. Adsorption behaviour determined ζ potential measurements shows that is strongly adsorbed on surface. It was found higher pH, Ca present surface, but followed this trend only up pH 7.4. Results suggest ions are not sites also TiO2 groups formed after When both simultaneously added in modified simulated body fluid containing titanate, 37°C, growth occurs 1 week immersion. © 2005 Wiley Periodicals, Inc. J Biomed Mater Res,

参考文章(30)
T HANAWA, M KON, H DOI, H UKAI, K MURAKAMI, H HAMANAKA, K ASAOKA, Amount of hydroxyl radical on calcium-ion-implanted titanium and point of zero charge of constituent oxide of the surface-modified layer. Journal of Materials Science: Materials in Medicine. ,vol. 9, pp. 89- 92 ,(1998) , 10.1023/A:1008847014938
Y. Fujishiro, N. Sato, S. Uchida, T. Sato, Coating of CaTiO3 on titanium substrates by hydrothermal reactions using calcium-ethylene diamine tetra acetic acid chelate. Journal of Materials Science: Materials in Medicine. ,vol. 9, pp. 363- 367 ,(1998) , 10.1023/A:1013201627622
Juan Coreño, Antonia Martínez, Oscar Coreño, Ana Bolarín, Félix Sánchez, Calcium and phosphate adsorption as initial steps of apatite nucleation on sol‐gel‐prepared titania surface Journal of Biomedical Materials Research Part A. ,vol. 64, pp. 131- 137 ,(2003) , 10.1002/JBM.A.10395
Y.G Bérubé, P.L de Bruyn, Adsorption at the rutile-solution interface Journal of Colloid and Interface Science. ,vol. 27, pp. 305- 318 ,(1968) , 10.1016/0021-9797(68)90038-6
L. -D. Piveteau, M. I. Girona, L. Schlapbach, P. Barboux, J. -P. Boilot, B. Gasser, Thin films of calcium phosphate and titanium dioxide by a sol-gel route: a new method for coating medical implants. Journal of Materials Science: Materials in Medicine. ,vol. 10, pp. 161- 167 ,(1999) , 10.1023/A:1008985423644
K. A. Khor, P. Cheang, Y. Wang, The thermal spray processing of HA powders and coatings JOM. ,vol. 49, pp. 51- 57 ,(1997) , 10.1007/BF02915482
T. Peltola, M. Jokinen, S. Veittola, J. Simola, A. Yli-Urpo, In vitro bioactivity and structural features of mildly heat‐treated sol‐gel‐derived silica fibers Journal of Biomedical Materials Research. ,vol. 54, pp. 579- 590 ,(2001) , 10.1002/1097-4636(20010315)54:4<579::AID-JBM150>3.0.CO;2-Q
M�nica Calixto de Andrade, Maria R. T. Filgueiras, Tsuneharu Ogasawara, Nucleation and growth of hydroxyapatite on titanium pretreated in NaOH solution: experiments and thermodynamic explanation. Journal of Biomedical Materials Research. ,vol. 46, pp. 441- 446 ,(1999) , 10.1002/(SICI)1097-4636(19990915)46:4<441::AID-JBM1>3.0.CO;2-9
C. C. Chusuei, D. W. Goodman, M. J. Van Stipdonk, D. R. Justes, K. H. Loh, E. A. Schweikert, Solid-Liquid Adsorption of Calcium Phosphate on TiO2 Langmuir. ,vol. 15, pp. 7355- 7360 ,(1999) , 10.1021/LA9905160
Mika Jokinen, Marko P�tsi, Hanna Rahiala, Timo Peltola, Mikko Ritala, J. B. Rosenholm, Influence of sol and surface properties on in vitro bioactivity of sol‐gel‐derived TiO2 and TiO2‐SiO2 films deposited by dip‐coating method Journal of Biomedical Materials Research. ,vol. 42, pp. 295- 302 ,(1998) , 10.1002/(SICI)1097-4636(199811)42:2<295::AID-JBM15>3.0.CO;2-I