Liquid piston gas compression

作者: James D. Van de Ven , Perry Y. Li

DOI: 10.1016/J.APENERGY.2008.12.001

关键词:

摘要: Abstract A liquid piston concept is proposed to improve the efficiency of gas compression and expansion. Because a can conform an irregular chamber volume, surface area volume ratio in be maximized using piston. This creates near-isothermal operation, which minimizes energy lost heat generation. eliminates leakage replaces sliding seal friction with viscous friction. The also used as medium carry into out chamber. simulation presented transfer frictional forces for reciprocating In application air compressor, pressure 9.5:1 cycle frequency 20 Hz, decreased consumption by 19% over exhibited total 83% 70% respectively. demonstrated significant improvements comparison conventional gain was accomplished through increasing during

参考文章(25)
David L. Howard, Liquid piston heat engine ,(1992)
Donald R. Cutler, Liquid piston heat pump ,(1983)
Alan Abram Kornhauser, Gas-wall heat transfer during compression and expansion Massachusetts Institute of Technology. ,(1989)
Yunus A. Cengel, Heat Transfer: A Practical Approach ,(1997)
Rogerio P. Klüppel, JoséMaurício M. Gurgel, Thermodynamic cycle of a liquid piston pump Renewable Energy. ,vol. 13, pp. 261- 268 ,(1998) , 10.1016/S0960-1481(97)00049-9
Ma Guoyuan, Yan Qisen, Yu Yongzhang, Dynamic Behavior of Twin-Piece Vane Machine Journal of Mechanical Design. ,vol. 124, pp. 74- 78 ,(2002) , 10.1115/1.1401455
Ozgen Akalin, Golam M. Newaz, Piston Ring-Cylinder Bore Friction Modeling in Mixed Lubrication Regime: Part I—Analytical Results Journal of Tribology-transactions of The Asme. ,vol. 123, pp. 211- 218 ,(2001) , 10.1115/1.1286337