Effect of Cutting Tool Materials on Surface Roughness and Cutting Forces in Machining of Al-Si3N4 Composite Produced by Powder Metallurgy
作者： Yusuf Ozcatalbas , Ersin Bahceci , Mehmet Turker
DOI: 10.4028/WWW.SCIENTIFIC.NET/MSF.534-536.869
关键词:
摘要: … Particle size of mixed powder was measured by Malvern Master Sizer E version 1.2b laser scattering machine. Then mixed powders were compacted at 800 MPa pressure in a double …
sci-hub.se 参考文章(6)
Quan Yanming, Zhou Zehua, Tool wear and its mechanism for cutting SiC particle-reinforced aluminium matrix composites Journal of Materials Processing Technology. ,vol. 100, pp. 194- 199 ,(2000) , 10.1016/S0924-0136(99)00405-7
Caroline J.E Andrewes, Hsi-Yung Feng, W.M Lau, Machining of an aluminum/SiC composite using diamond inserts Journal of Materials Processing Technology. ,vol. 102, pp. 25- 29 ,(2000) , 10.1016/S0924-0136(00)00425-8
S.C. Lim, M. Gupta, L. Ren, J.K.M. Kwok, The tribological properties of Al–Cu/SiCp metal–matrix composites fabricated using the rheocasting technique Journal of Materials Processing Technology. ,vol. 89, pp. 591- 596 ,(1999) , 10.1016/S0924-0136(99)00067-9
Y.M Quan, Z.H Zhou, B.Y Ye, Cutting process and chip appearance of aluminum matrix composites reinforced by SiC particle Journal of Materials Processing Technology. ,vol. 91, pp. 231- 235 ,(1999) , 10.1016/S0924-0136(98)00444-0
A. Manna, B. Bhattacharayya, A study on machinability of Al/SiC-MMC Journal of Materials Processing Technology. ,vol. 140, pp. 711- 716 ,(2003) , 10.1016/S0924-0136(03)00905-1
Y Ozcatalbas, Investigation of the machinability behaviour of Al4C3 reinforced Al-based composite produced by mechanical alloying technique Composites Science and Technology. ,vol. 63, pp. 53- 61 ,(2003) , 10.1016/S0266-3538(02)00177-X