Silicon carbonitride ceramic surface-modified nanoporous aluminum alloy by preceramic polysilazane precursor for surface strengthening
作者： Lung-Hao Hu , Yu-Kai Wang
DOI: 10.1016/J.MSEB.2021.115113
关键词:
摘要: Abstract Preceramic polysilazane precursor is simply coated on the anodized 7003 alloy and pyrolyzed at 400, 500 600 °C, respectively to form a silicon carbonitride ceramic film. The scanning transmission electron microscopic images show that film can be detected surface of anodic aluminum oxide compactly, representing multilayer structure with films SiCN, SiCN (AAO) layer substrate. wear test built-up by stainless steel velvet head reciprocating movement. After wearing in 2.176 km, rate 600 °C about 0.003%, extremely lower than alloy, 0.023%. average hardness indentation modulus elasticity achieve higher 6 GPa 85–90 GPa are twice those alloy.
sci-hub.st 参考文章(35)
Kai Su, Edward E. Remsen, Gregg A. Zank, Larry G. Sneddon, Synthesis, characterization, and ceramic conversion reactions of borazine-modified hydridopolysilazanes : new polymeric precursors to SiNCB ceramic composites Chemistry of Materials. ,vol. 5, pp. 547- 556 ,(1993) , 10.1021/CM00028A024
Dmitry G. Eskin, Andrey A. Aksenov, Nikolay A. Belov, Multicomponent Phase Diagrams: Applications for Commercial Aluminum Alloys ,(2005)
Lloyd Kamo, Roy Kamo, Edgars Valdmanis, Ceramic Coatings for Aluminum Engine Blocks SAE Technical Paper Series. ,(1991) , 10.4271/911719
C.A. Charitidis, S. Logothetidis, Effects of normal load on nanotribological properties of sputtered carbon nitride films Diamond and Related Materials. ,vol. 14, pp. 98- 108 ,(2005) , 10.1016/J.DIAMOND.2004.07.022
J Musil, F Kunc, H Zeman, H Poláková, Relationships between hardness, Young's modulus and elastic recovery in hard nanocomposite coatings Surface & Coatings Technology. ,vol. 154, pp. 304- 313 ,(2002) , 10.1016/S0257-8972(01)01714-5
Emanuel Ionescu, Hans-Joachim Kleebe, Ralf Riedel, Silicon-containing polymer-derived ceramic nanocomposites (PDC-NCs): preparative approaches and properties. Chemical Society Reviews. ,vol. 41, pp. 5032- 5052 ,(2012) , 10.1039/C2CS15319J
A Leyland, A Matthews, On the significance of the H/E ratio in wear control: a nanocomposite coating approach to optimised tribological behaviour Wear. ,vol. 246, pp. 1- 11 ,(2000) , 10.1016/S0043-1648(00)00488-9
Narayanan Janakiraman, Fritz Aldinger, Fabrication and characterization of fully dense Si–C–N ceramics from a poly(ureamethylvinyl)silazane precursor Journal of The European Ceramic Society. ,vol. 29, pp. 163- 173 ,(2009) , 10.1016/J.JEURCERAMSOC.2008.05.028
Aylin Karakuscu, Andrea Ponzoni, Parakkulam R. Aravind, Giorgio Sberveglieri, Gian D. Soraru, Gas Sensing Behavior of Mesoporous SiOC Glasses Journal of the American Ceramic Society. ,vol. 96, pp. 2366- 2369 ,(2013) , 10.1111/JACE.12491
Wojciech J. Stępniowski, Dominika Forbot, Małgorzata Norek, Marta Michalska-Domańska, Artur Król, The impact of viscosity of the electrolyte on the formation of nanoporous anodic aluminum oxide Electrochimica Acta. ,vol. 133, pp. 57- 64 ,(2014) , 10.1016/J.ELECTACTA.2014.04.039