Electrochemical saw using pulsating voltage
作者： M. Datta , D. Landolt
DOI: 10.1007/BF00615829
关键词: Operating variables 、 Electrolyte 、 Cutting tool 、 Nickel 、 Electrochemistry 、 Voltage 、 Materials science 、 Electrochemical machining 、 Machine tool 、 Metallurgy 、 Materials Chemistry 、 General Chemical Engineering
摘要: An electrochemical process for cutting metals and conducting refractory materials using a pulsating voltage has been developed. A laboratory type saw is described which successfully applied to cut different sintered V2O3. The influence of operating variables on rate precision studied the nickel in nitrate electrolyte.
springer.com
sci-hub.se 参考文章(6)
John Fay Wilson, Practice and theory of electrochemical machining Wiley-Interscience. ,(1971)
J. A. McGeough, Principles of electrochemical machining ,(1974)
Madhav Datta, Dieter Landolt, On the role of mass transport in high rate dissolution of iron and nickel in ECM electrolytes—I. Chloride solutions Electrochimica Acta. ,vol. 25, pp. 1255- 1262 ,(1980) , 10.1016/0013-4686(80)87130-1
M. Datta, D. Landolt, High rate transpassive dissolution of nickel with pulsating current Electrochimica Acta. ,vol. 27, pp. 385- 390 ,(1982) , 10.1016/0013-4686(82)85011-1
M. Datta, D. Landolt, Electrochemical machining under pulsed current conditions Electrochimica Acta. ,vol. 26, pp. 899- 907 ,(1981) , 10.1016/0013-4686(81)85053-0
Dieter Landolt, Throwing Power Measurements during High Rate Nickel Dissolution under Active and Transpassive Conditions Journal of The Electrochemical Society. ,vol. 119, pp. 708- 712 ,(1972) , 10.1149/1.2404300