Modelling and simulation of flow, heat transfer and cure
作者： Suresh G. Advani , Pavel Simácek
DOI: 10.1007/978-94-011-4437-7_8
关键词:
摘要: The resin transfer moulding (RTM) process consists of five consecutive stages, as shown in Figure 8.1. These are: draping the mould with a preform closing mould resin injection curing demoulding
springer.com
springerlink.com参考文章(52)
Y. DE PARSEVAL, K. M. PILLAI, S. G. ADVANI, A Simple Model for the Variation of Permeability due to Partial Saturation in Dual Scale Porous Media Transport in Porous Media. ,vol. 27, pp. 243- 264 ,(1997) , 10.1023/A:1006544107324
C. Galiotis, Proceedings of the American Society for composites Materials & Design. ,vol. 9, pp. 304- ,(1988) , 10.1016/0261-3069(88)90023-4
Pavel Simacek, Vistasp M. Karbhari, Notes on the Modeling of Preform Compaction: I -Micromechanics at the Fiber Bundle Level Journal of Reinforced Plastics and Composites. ,vol. 15, pp. 86- 122 ,(1996) , 10.1177/073168449601500106
Takashi Komori, Motoyoshi Itoh, Akira Takaku, A Model Analysis of the Compressibility of Fiber Assemblies Textile Research Journal. ,vol. 62, pp. 567- 574 ,(1992) , 10.1177/004051759206201002
Vistasp M. Karbhari, Pavel Simacek, Notes on the Modeling of Preform Compaction: II-Effect of Sizing on Bundle Level Micromechanics Journal of Reinforced Plastics and Composites. ,vol. 15, pp. 837- 861 ,(1996) , 10.1177/073168449601500807
Thomas L. Luce, Suresh G. Advani, J. Grant Howard, Richard S. Parnas, Permeability characterization. Part 2: Flow behavior in multiple‐layer preforms Polymer Composites. ,vol. 16, pp. 446- 458 ,(1995) , 10.1002/PC.750160603
Pavel šimáček, Victor N. Kaliakin, R. Byron Pipes, Pathologies associated with the numerical analysis of hyper-anisotropic materials International Journal for Numerical Methods in Engineering. ,vol. 36, pp. 3487- 3508 ,(1993) , 10.1002/NME.1620362006
R. Postle, A. H. Norton, Mechanics of complex fabric deformation and drape Journal of Applied Polymer Science. ,vol. 47, pp. 323- 340 ,(1991) , 10.1002/APP.1991.070470021
M. V. Bruschke, S. G. Advani, A finite element/control volume approach to mold filling in anisotropic porous media Polymer Composites. ,vol. 11, pp. 398- 405 ,(1990) , 10.1002/PC.750110613
C. M. van Wyk, 20—NOTE ON THE COMPRESSIBILITY OF WOOL Journal of The Textile Institute Transactions. ,vol. 37, ,(1946) , 10.1080/19447024608659279