High-speed turning experiments on metal matrix composites
作者： L. Iuliano , L. Settineri , A. Gatto
DOI: 10.1016/S1359-835X(98)00105-5
关键词:
摘要: Abstract The hard abrasive ceramic component which increases the mechanical characteristics of metal matrix composites (MMC) causes quick wear and premature tool failure in machining operations. aim paper is to compare behaviour high rake angle carbide tools with their diamond coated versions high-speed an Al 2 O 3 6061 MMC. influence cutting parameters, particular feed speed, on surface finish has been investigated. higher abrasion resistance coatings results increased life performances different chip formation mechanisms.
elsevier.com
sci-hub.se 参考文章(15)
Andrea Gatto, V. Tagliaferri, L. Iuliano, High speed turning of metal matrix composites with tools of different material and geometry Energy-Sources Technology Conference and Exhibition. ,vol. 71, pp. 89- 95 ,(1995)
A. Gatto, Luca Iuliano, Luca Settineri, High-Speed Turning of Metal Matrix Composites with Coated and Uncoated Carbide Tools 30th International Symposium on Automotive Technology & Automation. ,(1997)
Andrea Gatto, L. Iuliano, V. Tagliaferri, R. Ippolito, Surface finish of metal matrix composite under high speed turning 2nd Biennial European Joint Conference on Engineering Systems Design and Analysis. pp. 35- 42 ,(1994)
E. Bergmann, H. K. Pulker, Wear and corrosion resistant coatings by CVD and PVD E. Horwood , Halsted Press. ,(1989)
P.D. Townsend, Defects in coatings Thin Solid Films. pp. 342- 349 ,(1990) , 10.1016/S0040-6090(05)80044-6
I.S. Jawahir, C.A. van Luttervelt, Recent Developments in Chip Control Research and Applications CIRP Annals. ,vol. 42, pp. 659- 693 ,(1993) , 10.1016/S0007-8506(07)62531-1
Z.J. Yuan, L. Geng, S. Dong, Ultraprecision machining of SiCw/Al composites CIRP Annals. ,vol. 42, pp. 107- 109 ,(1993) , 10.1016/S0007-8506(07)62403-2
I. A. Ibrahim, F. A. Mohamed, E. J. Lavernia, Particulate reinforced metal matrix composites — a review Journal of Materials Science. ,vol. 26, pp. 1137- 1156 ,(1991) , 10.1007/BF00544448
L.A. Looney, J.M. Monaghan, P. O'Reilly, D.M.R. Taplin, The turning of an Al/SiC metal-matrix composite Journal of Materials Processing Technology. ,vol. 33, pp. 453- 468 ,(1992) , 10.1016/0924-0136(92)90279-2
N. Tomac, K. Tannessen, F.O. Rasch, Machinability of Particulate Aluminium Matrix Composites CIRP Annals. ,vol. 41, pp. 55- 58 ,(1992) , 10.1016/S0007-8506(07)61151-2