Fiber orientation prediction in injection molding
作者： T. Matsuoka
DOI: 10.1007/978-94-011-0523-1_3
关键词:
摘要: Short-fiber-reinforced polypropylene (FRPP) is used as a structural material because of its high strength and stiffness to weight cost. It can be easily processed by injection molding, which common method make products from thermoplastics. Since the properties molded parts FRPP are strongly affected fiber orientation, it important control orientation appropriately design molds parts.
springer.com
sci-hub.st 参考文章(31)
Richard C. Givler, Numerically Predicted Fiber Orientations in Dilute Suspensions ,(1981)
Takaaki MATSUOKA, Jun-ichi TAKABATAKE, Yoshinori INOUE, Hideroh TAKAHASHI, 射出成形充填・保圧・冷却過程における樹脂流動挙動のシミュレーション Kobunshi Ronbunshu. ,vol. 48, pp. 137- 144 ,(1991) , 10.1295/KORON.48.137
G�nther Fischer, Peter Eyerer, Measuring spatial orientation of short fiber reinforced thermoplastics by image analysis Polymer Composites. ,vol. 9, pp. 297- 304 ,(1988) , 10.1002/PC.750090409
Musa R. Kamal, Li Song, Peter Singh, Measurement of fiber and matrix orientations in fiber reinforced composites Polymer Composites. ,vol. 7, pp. 323- 329 ,(1986) , 10.1002/PC.750070509
R. J. Crowson, M. J. Folkes, Rheology of short glass fiber-reinforced thermoplastics and its application to injection molding. II. The effect of material parameters Polymer Engineering and Science. ,vol. 20, pp. 934- 940 ,(1980) , 10.1002/PEN.760201404
M. Cengiz Altan, S. Subbiah, Selçuk I. Güçeri, R. Byron Pipes, Numerical prediction of three-dimensional fiber orientation in Hele-Shaw flows Polymer Engineering and Science. ,vol. 30, pp. 848- 859 ,(1990) , 10.1002/PEN.760301408
M. Vincent, J. F. Agassant, Experimental and theoretical study of short fiber orientation in diverging flows Rheologica Acta. ,vol. 24, pp. 603- 610 ,(1985) , 10.1007/BF01332594
T. B. Lewis, L. E. Nielsen, Dynamic mechanical properties of particulate-filled composites Journal of Applied Polymer Science. ,vol. 14, pp. 1449- 1471 ,(1970) , 10.1002/APP.1970.070140604
S. Kenig, Fiber orientation development in molding of polymer composites Polymer Composites. ,vol. 7, pp. 50- 55 ,(1986) , 10.1002/PC.750070110
P. F. Bright, R. J. Crowson, M. J. Folkes, A study of the effect of injection speed on fibre orientation in simple mouldings of short glass fibre-filled polypropylene Journal of Materials Science. ,vol. 13, pp. 2497- 2506 ,(1978) , 10.1007/BF00808067