Optimization of multiple-machining characteristics in wire electrical discharge machining of punching die using Grey relational analysis
作者： Kamal Jangra , Ajai Jain , Sandeep Grover , None
DOI:
关键词:
摘要: … by 1 or 2 trim cuts were considered as a probable solution. Trim cutting operation improves … Trim cut improves die life by reducing thickness of thermally affected formed layer. In rough …
niscair.res.in
niscpr.res.in参考文章(17)
J. L. Deng, Introduction to Grey system theory Journal of Grey System. ,vol. 1, pp. 1- 24 ,(1989) , 10.5555/90757.90758
J.L Lin, C.L Lin, The use of the orthogonal array with grey relational analysis to optimize the electrical discharge machining process with multiple performance characteristics International Journal of Machine Tools & Manufacture. ,vol. 42, pp. 237- 244 ,(2002) , 10.1016/S0890-6955(01)00107-9
A.B. Puri, B. Bhattacharyya, Modeling and analysis of white layer depth in a wire-cut EDM process through response surface methodology The International Journal of Advanced Manufacturing Technology. ,vol. 25, pp. 301- 307 ,(2005) , 10.1007/S00170-003-2045-8
Che-Chung Wang, Han-Ming Chow, Lieh-Dai Yang, Chun-Te Lu, Recast layer removal after electrical discharge machining via Taguchi analysis: A feasibility study Journal of Materials Processing Technology. ,vol. 209, pp. 4134- 4140 ,(2009) , 10.1016/J.JMATPROTEC.2008.10.012
A.B Puri, B Bhattacharyya, An analysis and optimisation of the geometrical inaccuracy due to wire lag phenomenon in WEDM International Journal of Machine Tools and Manufacture. ,vol. 43, pp. 151- 159 ,(2003) , 10.1016/S0890-6955(02)00158-X
Deng Ju-Long, Control problems of grey systems Systems & Control Letters. ,vol. 1, pp. 288- 294 ,(1982) , 10.1016/S0167-6911(82)80025-X
Nihat Tosun, Can Cogun, Gul Tosun, A study on kerf and material removal rate in wire electrical discharge machining based on Taguchi method Journal of Materials Processing Technology. ,vol. 152, pp. 316- 322 ,(2004) , 10.1016/J.JMATPROTEC.2004.04.373
DAN SCOTT, SREEDHAR BOYINA, K. P. RAJURKAR, Analysis and optimization of parameter combinations in wire electrical discharge machining International Journal of Production Research. ,vol. 29, pp. 2189- 2207 ,(1991) , 10.1080/00207549108948078
Chorng-Jyh Tzeng, Yu-Hsin Lin, Yung-Kuang Yang, Ming-Chang Jeng, Optimization of turning operations with multiple performance characteristics using the Taguchi method and Grey relational analysis Journal of Materials Processing Technology. ,vol. 209, pp. 2753- 2759 ,(2009) , 10.1016/J.JMATPROTEC.2008.06.046
Nihat Tosun, Can Cogun, An investigation on wire wear in WEDM Journal of Materials Processing Technology. ,vol. 134, pp. 273- 278 ,(2003) , 10.1016/S0924-0136(02)01045-2