Modeling of Depth of Cut in Abrasive Waterjet Cutting of Thick Kevlar-Epoxy Composites
作者： Tauseef Uddin Siddiqui , Mukul Shukla
DOI: 10.4028/WWW.SCIENTIFIC.NET/KEM.443.423
关键词:
摘要: Abrasive water jet cutting (AWJC) is one of the widely used non-conventional techniques for difficult-to-cut materials like composites, super alloys and ceramics. However, while conducting initial trials inability to cut through workpiece a major problem particularly in thicker materials. Therefore an accurate prediction depth (DOC) absolutely necessary achieve cuts more so minimize delamination polymer matrix composites. In this paper, semi-empirical model developed using non-linear regression analysis DOC AWJC thick Kevlar-epoxy Further, verified by experiments within investigated range process parameters good agreement obtained between two.
sci-hub.se 参考文章(10)
Gi Sang Choi, Gi Heung Choi, Process analysis and monitoring in abrasive water jet machining of alumina ceramics International Journal of Machine Tools & Manufacture. ,vol. 37, pp. 295- 307 ,(1997) , 10.1016/S0890-6955(96)00049-1
G. Vikram, N. Ramesh Babu, Modelling and analysis of abrasive water jet cut surface topography International Journal of Machine Tools & Manufacture. ,vol. 42, pp. 1345- 1354 ,(2002) , 10.1016/S0890-6955(02)00064-0
J Wang, D.M Guo, A predictive depth of penetration model for abrasive waterjet cutting of polymer matrix composites Journal of Materials Processing Technology. ,vol. 121, pp. 390- 394 ,(2002) , 10.1016/S0924-0136(01)01246-8
J.G.A. Bitter, A study of erosion phenomena part I Wear. ,vol. 6, pp. 5- 21 ,(1963) , 10.1016/0043-1648(63)90003-6
C.A. van Luttervelt, On the Selection of Manufacturing Methods Illustrated by an Overview of Separation Techniques for Sheet Materials CIRP Annals. ,vol. 38, pp. 587- 607 ,(1989) , 10.1016/S0007-8506(07)61127-5
AA El-Domiaty, AA Abdel-Rahman, None, Fracture mechanics-based model of abrasive waterjet cutting for brittle materials The International Journal of Advanced Manufacturing Technology. ,vol. 13, pp. 172- 181 ,(1997) , 10.1007/BF01305869
J. Wang, Predictive depth of jet penetration models for abrasive waterjet cutting of alumina ceramics International Journal of Mechanical Sciences. ,vol. 49, pp. 306- 316 ,(2007) , 10.1016/J.IJMECSCI.2006.09.005
Ambuj Saxena, S. Paul, Numerical modelling of kerf geometry in abrasive water jet machining International Journal of Abrasive Technology. ,vol. 1, pp. 208- ,(2007) , 10.1504/IJAT.2007.015385
Mohamed Hashish, A Modeling Study of Metal Cutting With Abrasive Waterjets Journal of Engineering Materials and Technology-transactions of The Asme. ,vol. 106, pp. 88- 100 ,(1984) , 10.1115/1.3225682
J. Wang, Abrasive Waterjet Machining of Polymer Matrix Composites Cutting Performance, Erosive Process and Predictive Models The International Journal of Advanced Manufacturing Technology. ,vol. 15, pp. 757- 768 ,(1999) , 10.1007/S001700050129