Mixed Bed Ion Exchange for the Removal of Radioactivity
作者： H. Gladys Swope
DOI: 10.1002/J.1551-8833.1957.TB16910.X
关键词:
摘要: Experimental work using mixed bed ion-exchange resins for removing old fission products from tap water showed that the highest decontamination factors were obtained when was adjusted to pH 2.5 with nitric acid. This adjustment increased anion content of and it is therefore recommended a 3:1 ratio cation resin be used. Flow rate appears an important consideration in radioactivity should not exceed 2 gpm per cubic foot resin. The capacity exchanger removal based on amount total dissolved solids feed. lower larger throughput. (auth)
sci-hub.st 参考文章(7)
J.M. Seamon, H.F. Beeghly, D.M. Wroughton, WATER TECHNOLOGY FOR PRIMARY SYSTEMS IN WATER-COOLED POWER REACTORS Chemical Engineering Progress. ,(1956)
M. Sivetz, RADIOACTIVITY INDUCED IN WATER Atomics (Chicago). ,(1950)
S.A. Reynolds, W.S. Lyon, RADIOACTIVE SPECIES INDUCED IN REACTOR COOLING WATER Nucleonics (U.S.) Ceased publication. ,(1955)
R. A. Lauderdale, A. H. Emmons, A Method for Decontaminating Small Volumes of Radioactive Water Journal - American Water Works Association. ,vol. 43, pp. 326- 331 ,(1951) , 10.1002/J.1551-8833.1951.TB18948.X
H. Gladys Swope, Elaine Anderson, Cation Exchange Removal of Radioactivity from Wastes Industrial & Engineering Chemistry. ,vol. 47, pp. 78- 83 ,(1955) , 10.1021/IE50541A031
John A. Ayres, Treatment of Radioactive Waste by Ion Exchange Industrial & Engineering Chemistry. ,vol. 43, pp. 1526- 1531 ,(1951) , 10.1021/IE50499A021
H. W. Huntley, S. Untermyer, The Use of Water in Atomic Reactors ASTM International. ,(1956) , 10.1520/STP44094S