Analysis and optimization of surface finish of wire electrical discharge machined miniature gears
作者： Kapil Gupta , Neelesh K Jain
关键词:
摘要: This article reports about analysis and optimization of surface roughness parameters (i.e. average Ra maximum Rt) wire electrical discharge machined fine-pitch miniature spur gears made brass. Effects four machining process voltage, pulse-on time, pulse-off time feed rate) on the were studied by conducting 29 experiments with two replicates each designed based Box–Behnken approach response methodology. Analysis variance study found all input to be significant. Experimentally, has been increase higher voltage longer decrease rate. Desirability was used optimize parameters, so as minimize Rt simultaneously. Optimum values obtained from confirmation ex...
sagepub.com
sci-hub.se 参考文章(20)
Darle W. Dudley, Dennis P. Townsend, Dudley's Gear Handbook ,(1991)
Laurene V. Fausett, Fundamentals of neural networks ,(1993)
J.A. Walraven, Failure mechanisms in mems international test conference. ,vol. 1, pp. 828- 833 ,(2003) , 10.1109/TEST.2003.1270915
Nihat Tosun, Can Cogun, A Inan, The Effect of Cutting Parameters on Workpiece Surface Roughness in Wire EDM Machining Science and Technology. ,vol. 7, pp. 209- 219 ,(2003) , 10.1081/MST-120022778
Wenming Zhang, Guang Meng, Hongguang Li, Electrostatic micromotor and its reliability Microelectronics Reliability. ,vol. 45, pp. 1230- 1242 ,(2005) , 10.1016/J.MICROREL.2004.12.017
Kapil Gupta, Neelesh Kumar Jain, On Micro-Geometry of Miniature Gears Manufactured by Wire Electrical Discharge Machining Materials and Manufacturing Processes. ,vol. 28, pp. 1153- 1159 ,(2013) , 10.1080/10426914.2013.792422
Sunil Sheshrao Baraskar, S. S. Banwait, S. C. Laroiya, Multiobjective Optimization of Electrical Discharge Machining Process Using a Hybrid Method Materials and Manufacturing Processes. ,vol. 28, pp. 348- 354 ,(2013) , 10.1080/10426914.2012.700152
Mohammad Yeakub Ali, Ammar Sami Mohammad, Effect of Conventional EDM Parameters on the Micromachined Surface Roughness and Fabrication of a Hot Embossing Master Microtool Materials and Manufacturing Processes. ,vol. 24, pp. 454- 458 ,(2009) , 10.1080/10426910802714373
C-J Tzeng, Y-K Yang, M-H Hsieh, M-C Jeng, Optimization of wire electrical discharge machining of pure tungsten using neural network and response surface methodology Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture. ,vol. 225, pp. 841- 852 ,(2011) , 10.1243/09544054JEM2021
Mohammad Yeakub Ali, Ammar Sami Mohammad, Experimental Study of Conventional Wire Electrical Discharge Machining for Microfabrication Materials and Manufacturing Processes. ,vol. 23, pp. 641- 645 ,(2008) , 10.1080/10426910802316492