Spark erosion machining of miniature gears: a critical review
作者： Kapil Gupta , N. K. Jain , R. F. Laubscher
DOI: 10.1007/S00170-015-7130-2
关键词:
摘要: This paper presents a review of previous work conducted as regards to the machining miniature gears by spark erosion (SEM) process and its variants. Miniature are key components various small devices. Their proper function requires selection an appropriate manufacturing and/or finishing that will deliver required fit for purpose quality. Spark-erosion-based processes have proven track record impart relevant quality characteristics minimize number operations required. commences with introduction before outlining gears. Details efforts on these SEM-based presented selected future research trends, directions avenues possible offered. focuses exclusively SEM even though it is noted similar macrogears also limited. aims facilitate overall view all available literature in single article, promote technology provide road map researchers making towards exploring technologies further.
springer.com
sci-hub.se 参考文章(35)
Advanced Analysis of Nontraditional Machining Springer New York. ,(2013) , 10.1007/978-1-4614-4054-3
Darle W. Dudley, Dennis P. Townsend, Dudley's Gear Handbook ,(1991)
Tai-Ran Hsu, MEMS and Microsystems: Design, Manufacture, and Nanoscale Engineering ,(2008)
J. A. McGeough, Advanced methods of machining ,(1988)
J.A. Walraven, Failure mechanisms in mems international test conference. ,vol. 1, pp. 828- 833 ,(2003) , 10.1109/TEST.2003.1270915
H. Takeuchi, K. Nakamura, N. Shimizu, N. Shibaike, Optimization of mechanical interface for a practical micro-reducer international conference on micro electro mechanical systems. pp. 170- 175 ,(2000) , 10.1109/MEMSYS.2000.838511
Kapil Gupta, Neelesh K Jain, Analysis and optimization of surface finish of wire electrical discharge machined miniature gears Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture. ,vol. 228, pp. 673- 681 ,(2014) , 10.1177/0954405413508938
Kapil Gupta, Neelesh Kumar Jain, On Micro-Geometry of Miniature Gears Manufactured by Wire Electrical Discharge Machining Materials and Manufacturing Processes. ,vol. 28, pp. 1153- 1159 ,(2013) , 10.1080/10426914.2013.792422
A.K. Dokania, M. Pelle, P. Kruit, Fabrication of miniaturized Schottky emitter by wire electrical discharge machining (WEDM) Microelectronic Engineering. ,vol. 85, pp. 1031- 1034 ,(2008) , 10.1016/J.MEE.2007.12.040
K.H Ho, S.T Newman, S Rahimifard, R.D Allen, STATE OF THE ART IN WIRE ELECTRICAL DISCHARGE MACHINING (WEDM) International Journal of Machine Tools & Manufacture. ,vol. 44, pp. 1247- 1259 ,(2004) , 10.1016/J.IJMACHTOOLS.2004.04.017