Effect of screw design on fiber breakage and dispersion in injection-molded long glass-fiber-reinforced polypropylene
作者： Akira Inoue , Kazuya Morita , Tatsuya Tanaka , Yoshihiko Arao , Yasutake Sawada
关键词:
摘要: … obtained by autoclave, sheet molding compound (SMC), and resin transfer molding (RTM). … used in the injection molding of FRTPs. FRTPs produced by injection molding are thus not …
sagepub.com
harvard.edu
elsevier.com
sci-hub.se 参考文章(22)
J.L. Thomason, Micromechanical parameters from macromechanical measurements on glass reinforced polypropylene Composites Science and Technology. ,vol. 61, pp. 1455- 1468 ,(2001) , 10.1016/S0266-3538(01)00062-8
Can Yang, Han-Xiong Huang, Kun Li, Investigation of fiber orientation states in injection‐compression molded short‐fiber‐reinforced thermoplastics Polymer Composites. ,vol. 31, pp. 1899- 1908 ,(2010) , 10.1002/PC.20986
Toshio OGAWA, Masamichi MIMA, Naoki TAYA, Change of Fiber Length in Injection Molding of Carbon Fiber Reinforced Nylon 66 Seikei-kakou. ,vol. 7, pp. 315- 320 ,(1995) , 10.4325/SEIKEIKAKOU.7.315
R. Singh, F. Chen, F. R. Jones, Injection molding of glass fiber reinforced phenolic composites. 2 : Study of the injection molding process Polymer Composites. ,vol. 19, pp. 37- 47 ,(1998) , 10.1002/PC.10073
Y. Béreaux, J. Y. Charmeau, M. Moguedet, Modelling of fibre damage in single screw processing International Journal of Material Forming. ,vol. 1, pp. 827- 830 ,(2008) , 10.1007/S12289-008-0263-1
Ming Hsiung Ho, Pin Ning Wang, Chin Ping Fung, The Effect of Injection Molding Process Parameters on the Buckling Properties of PBT/Short Glass Fiber Composites Advanced Materials Research. pp. 550- 556 ,(2011) , 10.4028/WWW.SCIENTIFIC.NET/AMR.284-286.550
F. Rezaei, R. Yunus, N. A. Ibrahim, E. S. Mahdi, Development of Short-Carbon-Fiber-Reinforced Polypropylene Composite for Car Bonnet Polymer-plastics Technology and Engineering. ,vol. 47, pp. 351- 357 ,(2008) , 10.1080/03602550801897323
J. L. Thomason, Structure–property relationships in glass reinforced polyamide, part 2: The effects of average fiber diameter and diameter distribution Polymer Composites. ,vol. 28, pp. 331- 343 ,(2007) , 10.1002/PC.20260
Noriyo Ichinose, Masaru Ishikawa, Kiyoshi Morimoto, Effect of stress transfer between fiber and matrix on toughness of polymer composite Polymer Composites. ,vol. 32, pp. 1617- 1624 ,(2011) , 10.1002/PC.21200
J.L. Thomason, The influence of fibre length and concentration on the properties of glass fibre reinforced polypropylene: 5. Injection moulded long and short fibre PP Composites Part A-applied Science and Manufacturing. ,vol. 33, pp. 1641- 1652 ,(2002) , 10.1016/S1359-835X(02)00179-3