Pocketing toolpath optimization for sharp corners
作者： Z.Y. Zhao , C.Y. Wang , H.M. Zhou , Z. Qin
DOI: 10.1016/J.JMATPROTEC.2007.04.096
关键词:
摘要: … easily, and it is added at corner of pockets to make toolpath smooth in milling. … corners and the need of an efficient toolpath for pocket milling are pointed out. Corner transition of toolpath …
elsevier.com
researchgate.net 
sci-hub.se 参考文章(7)
M Held, G Lukács, L Andor, Pocket Machining Based on Contour-Parallel Tool Paths Generated by Means of Proximity Maps Computer-aided Design. ,vol. 26, pp. 189- 203 ,(1994) , 10.1016/0010-4485(94)90042-6
Byoung K. Choi, Bo H. Kim, Die-cavity pocketing via cutting simulation Computer-aided Design. ,vol. 29, pp. 837- 846 ,(1997) , 10.1016/S0010-4485(97)00031-6
Kunwoo Lee, Tae Ju Kim, Sung Eui Hong, Generation of toolpath with selection of proper tools for rough cutting process Computer-aided Design. ,vol. 26, pp. 822- 831 ,(1994) , 10.1016/0010-4485(94)90096-5
Millan K. Yeung, Desmond J. Walton, Curve fitting with arc splines for NC toolpath generation Computer-aided Design. ,vol. 26, pp. 845- 849 ,(1994) , 10.1016/0010-4485(94)90099-X
Yong Seok Suh, Kunwoo Lee, NC milling tool path generation for arbitrary pockets defined by sculptered surfaces Computer-aided Design. ,vol. 22, pp. 273- 284 ,(1990) , 10.1016/0010-4485(90)90092-Q
H.S. Choy, K.W. Chan, A corner-looping based tool path for pocket milling Computer-aided Design. ,vol. 35, pp. 155- 166 ,(2003) , 10.1016/S0010-4485(02)00049-0
Sun Quan-ping, Tool-Path Generation Algorithm on Automatic Recognition Uncut Free Pocketing for High-Speed Milling Journal of Nanjing University of Aeronautics and Astronautics. ,(2004)